Hostname: page-component-848d4c4894-jbqgn Total loading time: 0 Render date: 2024-06-22T07:10:18.872Z Has data issue: false hasContentIssue false

Analysis of Vibrational Properties of Thin Films Using in-Situ Infrared Ellipsometry: Applications to Polymerlike Amorphous Carbon Films

Published online by Cambridge University Press:  10 February 2011

T. Heitz
Affiliation:
Laboratoire de Physique des Interfaces et des Couches Minces (UMR 7647 du CNRS), Ecole Polytechnique, 91128 Palaiseau Cedex, France
B. Drevillon
Affiliation:
Laboratoire de Physique des Interfaces et des Couches Minces (UMR 7647 du CNRS), Ecole Polytechnique, 91128 Palaiseau Cedex, France
C. Godet
Affiliation:
Laboratoire de Physique des Interfaces et des Couches Minces (UMR 7647 du CNRS), Ecole Polytechnique, 91128 Palaiseau Cedex, France
J. E. Bouree
Affiliation:
Laboratoire de Physique des Interfaces et des Couches Minces (UMR 7647 du CNRS), Ecole Polytechnique, 91128 Palaiseau Cedex, France
C. Clerc
Affiliation:
Centre de Spectroscopie Nucléaire et de Spectroscopie de Masse, Université Paris-Sud, 91405 Orsay, France
Get access

Abstract

An original method is developed to investigate vibrational properties of thin films using infrared (IR) ellipsometry. The procedure is based on in-situ measurements as a function of deposition time. Out of absorption bands, the IR refractive index can be determined and related both to film density and oscillator strengths of electronic transitions. Thanks to band decomposition performed for a given film at different thicknesses, line frequency, band width and intensity of each vibration can be precisely determined, even in case of band overlapping or low IR oscillator strengths. As an illustration, C-H bonding of 1000 Å-thick plasmadeposited polymerlike hydrogenated carbon (PLC) films has been studied. Analysis of the interface between highly saturated PLC films and crystalline silicon reveals the formation of a 20 Å interlayer. Bulk analysis evidences weak vibrations located at 1405 and 1440 cm−1 which had not been observed so far and which are related to π bonds. By combining elastic recoil detection measurements and IR analysis, effective charges of sp3 CHn groups have been calculated. For methyl and methylene groups, these charges are similar to those of hydrocarbon compounds. As far as the sp3 CHn group is concerned, a strong decrease of the effective charge versus film density is evidenced and attributed to the formation of distorted weakly hydrogenated regions induced by ion bombardment.

Type
Research Article
Copyright
Copyright © Materials Research Society 1999

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Friedl, A., Fukarek, W., Mdller, W. and Koch, A., Rev. Sci. Instrum. 65, 2882 (1994).Google Scholar
2. Canillas, A., Pascual, E. and Drdvillon, B., Rev. Sci. Instrum. 64, 2153 (1993).Google Scholar
3. Etemadi, R., Godet, C., Perrin, J., Drvillon, B., Hue, J., Parey, J.Y., Rostaing, J.C. and Coeuret, F., J. Vac. Sci. Technol. A 15, 320 (1997).Google Scholar
4. Godet, C., Heitz, T., Drévillon, B., Bourée, J.E. and Clerc, C., J. Appl. Phys. 84, 3919 (1998).Google Scholar
5. Heitz, T., Drévillon, B., Godet, C. and Bourée, J.E., Phys. Rev B 58, 13957 (1998).Google Scholar
6. Heitz, T., Drévillon, B., Bourée, J.E. and Godet, C., Appl. Phys. Lett. 72, 780 (1998).Google Scholar
7. Wexler, A.S., Spectrochim. Acta 21, 1725 (1965).Google Scholar
8. Honeybone, P.J., Newport, R.J., Howells, W.S., Tomkinson, J., Bennington, S.B. and Revell, P.J., Chem. Phys. Lett. 180, 145 (1991).Google Scholar