Hostname: page-component-78c5997874-ndw9j Total loading time: 0 Render date: 2024-11-18T04:24:05.471Z Has data issue: false hasContentIssue false
  • English
  • Français

Optimization of the Properties of Undoped a-Ge:H*

Published online by Cambridge University Press:  25 February 2011

W. A. Turner ,
D. Pang ,
A. E. Wetsel ,
S. J. Jones ,
W. Paul  and
J.H. Chen
W. A. Turner
Affiliation:
Division of Applied Sciences, Harvard University, Cambridge, MA 02138
D. Pang
Affiliation:
Division of Applied Sciences, Harvard University, Cambridge, MA 02138
A. E. Wetsel
Affiliation:
Division of Applied Sciences, Harvard University, Cambridge, MA 02138
S. J. Jones
Affiliation:
Division of Applied Sciences, Harvard University, Cambridge, MA 02138
W. Paul
Affiliation:
Division of Applied Sciences, Harvard University, Cambridge, MA 02138
J.H. Chen
Affiliation:
Physics Department, Boston College, Chestnut Hill, MA 02167
Get access

Abstract

High density, non-porous, highly photoconductive films of undoped a-Ge:H showing minimal microstructure have been prepared out of an r.f. glow discharge of GeH4 on substrates mounted on the powered electrode of a diode reactor. These films, prepared under the systematic variation of substrate temperature, discharge power and dilution of the plasma by H2 are markedly different from those produced on the unpowered electrode. An optimum level of applied power is found which does not differ significantly from that used to prepare state-of-the-art a-Si:H. For the reactor geometry used, dilution of the plasma with H2 is found to be essential to the preparation of high quality a-Ge:H. These films contain similar amounts of bound hydrogen to that found in good a-Si:H, and also relatively large quantities of unbound hydrogen. Transport is activated with a Fermi level near mid-gap, the dangling bond spin density is 5 × 1016 spins/cm3, and the samples exhibit photoluminescence. The electron μÄ has been measured using the TOF technique. The conditions for preparation of optimized material are quite different for those found to optimize the preparation of high quality a-Si:H in this reactor. This is asserted to be a principal cause for our finding, along with other laboratories, of inferior properties for a-SiGe:H alloys when compared with those of a-Si:H.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 192: Symposium O – Amorphous Silicon Technology - 1990 , 1990 , 493
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Footnotes

*

Research supported by SERI contract XX-8-18131-1-1 and NSF Grant DMR-86-14003.

References

REFERENCES

Martin, D., Schroeder, B., Leidner, M., and Oechsner, H., J. Non-Cryst. Solids 114, 537 (1989).Google Scholar
Marques, F. C. and Chambouleyron, I., Proceedings of the 9th European Photovoltaic Solar Energy Conference, edited by Paltz, W., Wrixon, G.T., and Helm, P. (Kluwer Academic Publishers, Derdrecht, 1989), p. 1042.Google Scholar
3. Parsons, G. N., Kusano, C., and Lucovsky, G., J. Vac. Sci. Technol. A 5, 1655 (1987).Google Scholar
4. Maramatsu, S., Kajiyama, H., Itoh, H., Matsubara, S., and Shimada, T., 20th IEEE Photovoltaics Specialists Conference Proceedings 1. (IEEE, New York, NY, 1988), p. 61.Google Scholar
5. Haku, H., Sayama, K., Matsuoka, T., Tsuda, S., Nakano, S., Ohnishi, M., and Kuwano, Y., Jap. J. Appl. Phys. 28, 1323 (1989).Google Scholar
6. Karg, F. H., Böhm, H., and Pierz, K., J. Non-Cryst. Solids 114, 477 (1989).Google Scholar
7. Turner, W. A., Jones, S.J., Pang, D., Bateman, B.F., Chen, J.H., Li, Y.M., Marques, F.C., Wetsel, A.E., Wickboldt, P., Paul, W., Bodart, J., Norberg, R.E., El Zawawi, I., and Theye, M.L., J. Appl. Phys., in press.Google Scholar
8. Aoki, T., Kato, S., Nishikawa, Y., and Hirose, M., J. Non-Cryst. Solids 114, 798 (1989).Google Scholar
9. Jones, S.J., Lee, S.M., Turner, W.A., and Paul, W., in Amorphous Silicon Technology-1989. edited by Madan, A., Thompson, M.J., Taylor, P.C., Hamakawa, Y., and LeComber, P.G. (Mat. Res. Soc. Symp. Proc. 149, Pittsburgh, PA, 1989), pp. 45–50.Google Scholar
10. Li, Y. M., Turner, W.A., Lee, C., and Paul, W., in Amorphous Silicon Technology-1989. edited by Madan, A., Thompson, M.J., Taylor, P.C., Hamakawa, Y., and LeComber, P.G. (Mat. Res. Soc. Symp. Proc. 142, Pittsburgh, PA, 1989), pp. 187–192.Google Scholar
11. Turner, W. A, Jones, S.J., Lee, C., Lee, S.M., Li, Y.M., and Paul, W., in Amorphous Silicon Technology-1989. edited by Madan, A., Thompson, M.J., Taylor, P.C..Hamakawa, Y., and LeComber, P.G. (Mat. Res. Soc. Symp. Proc. 142, Pittsburgh, PA, 1989), pp. 69–74.Google Scholar
12. Jones, S. J., Turner, W.A., and Paul, W., J. Non-Cryst. Solids 114, 525 (1989).Google Scholar
13. Fang, C. J., Gruntz, K.J., Ley, L., Cardona, M., Demond, F.J., Muller, G., and Kalbitzer, S., J. Non-Cryst. Solids 35&36 255 (1980).Google Scholar
14. Oguz, S., Ph.D. thesis, Harvard University, 1981.Google Scholar