Hostname: page-component-7c8c6479df-nwzlb Total loading time: 0 Render date: 2024-03-28T10:37:33.799Z Has data issue: false hasContentIssue false

In‐situ growth of yba2cu3o7‐x films by metal organic chemical vapor deposition using vertical, high‐speed rotating disk reactor.

Published online by Cambridge University Press:  28 February 2011

D. W. Noh
Affiliation:
Stevens Institute of Technology, Dept. of Materials Science and Engineering, Hoboken, NJ
B. Gallois
Affiliation:
Stevens Institute of Technology, Dept. of Materials Science and Engineering, Hoboken, NJ
Y. Q. Li
Affiliation:
Stevens Institute of Technology, Dept. of Materials Science and Engineering, Hoboken, NJ
C. Chern
Affiliation:
Rutgers University, Dept. of Materials Science, Piscataway, NJ
B. Rear
Affiliation:
Rutgers University, Dept. of Materials Science, Piscataway, NJ
G. S. Tompa
Affiliation:
EMCORE Corp., 35 Elizabeth Ave., Somerset, NJ
P. Norris
Affiliation:
EMCORE Corp., 35 Elizabeth Ave., Somerset, NJ
P. Zawadzki
Affiliation:
Stevens Institute of Technology, Dept. of Materials Science and Engineering, Hoboken, NJ
Get access

Abstract

Superconducting thin films of YBa2Cu307‐x were grown on MgO (100) and YSZ(IOO) substrates without post‐annealing by metal organic chemical vapor deposition using vertical, high‐speed (1100 rpm) rotating disk reactor. The source materials were Y(tmhd)3, Ba(tmhd)2, and Cu(tmhd)2, which were kept at 135 °C, 240 °C, and 120 °C respectively. The precursors were transported using nitrogen as the carrier gas and introduced separately into the cylindrical stainless steel reaction chamber, which was maintained at 60 torr. The oxygen partial pressure was 30 Torr. The substrates were heated resistively at 800°C. After growth, the films were cooled down at a rate of 5 °C/min under 1 atmospheric pressure of pure oxygen. The X‐ray diffraction pattern of the films showed primarily an orientation of c‐axis perpendicular to the substrates, with weak peaks of (hoo) corresponding to a‐axis orientation. Scanning Electron Microscopy of the films showed a well‐developed a‐axis and c‐axis plate‐like structure which appeared as rectangular micron‐sized features on the MgO surface. On the YSZ substrates a‐axis and c‐axis plate‐like projections were also observed, with the dense plate‐like c‐axis orientation dominant. Four probe resistance measurements showed Tc(R=0) at 91.8 K(△TC=2.2 K) and 85 K (△TC=7 K) on YSZ and MgO substrates respectively.

Type
Research Article
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1 Wu, M.K., Ashburn, J.R., Tong, C.T., Hor, P.H., Meng, R.L., Gao, L., Hung, Z.J., Wang, Y.Q., and Chu, C.W., Phys. Rev. Lett. 58, 908 (1987)Google Scholar
2 Venkatesan, T., Wu, X.D., Dutta, B., Inam, A., Hedge, S., Hwang, D., Chang, C.C., Nazor, L. and Wilkens, B., Appl. Phys. Lett. 54, 581 (1989)Google Scholar
3 Hong, M., Liou, S.H., Kwo, J., and McGuire, T.R., Appl. Phys. Lett. 31, 694 (1987)Google Scholar
4 Kwo, J., Hsieh, J.C., Felmeng, R.M., Hong, M., Lu, S.H., Davidson, B.A., and Feldman, L.C., Phys. Rev. B36, 4039 (1987)Google Scholar
5 Koukitu, A., Hasegawa, Y., Seki, H., Kogima, H., Tanaka, I., and Kamioka, Y., Jap. J. Appl. Phys. 28,(7) L1212 (1989)Google Scholar
6 Yamane, H., Masumoto, H., Hirai, T., Iwasaki, H., Watanabe, K. Kobayashi, N. and Muto, Y., Appl. Phys. Lett. 53, 1548 (1988)Google Scholar
7 Tarascon, J.M., LePage, Y., Barboux, P., Bagley, B.G., Greene, L.H., McKinnon, W.R., Hull, G.W., Giroud, M., and Hwang, D.M., Phys. Rev. B37, 9387 (1988)Google Scholar
8 Noh, D.W., Gallois, B., Chern, C.S., Caracciolo, R., Kear, B.H., Zawadzki, P., Tompa, G.S., and Norris, P., J. Appl. Phys., in pressGoogle Scholar
9 Evans, G.H. and Grief, R., J. Heat Transfer 102, 928 (1987)Google Scholar