Hostname: page-component-78c5997874-g7gxr Total loading time: 0 Render date: 2024-11-18T16:38:33.452Z Has data issue: false hasContentIssue false
  • English
  • Français

Calorimetric and Spectroscopic Characterization of Zone Refined and Regrown Lead Lodide

Published online by Cambridge University Press:  10 February 2011

K.-T. Chen ,
A. Burger ,
H. Chen ,
Y.-F. Chen ,
K. Hansen ,
L. Suber ,
S. Wilson ,
J. Henderson ,
G. W. Wright  and
M. L. Cole
K.-T. Chen
Affiliation:
Current Address: Digirad Co., 7408 Trade street, San Diego, CA 92121.
A. Burger
Affiliation:
Center for Photonic Materials and Devices, Department of Physics, Fisk University, Nashville, TN 37208
H. Chen
Affiliation:
Center for Photonic Materials and Devices, Department of Physics, Fisk University, Nashville, TN 37208
Y.-F. Chen
Affiliation:
Center for Photonic Materials and Devices, Department of Physics, Fisk University, Nashville, TN 37208
K. Hansen
Affiliation:
Center for Photonic Materials and Devices, Department of Physics, Fisk University, Nashville, TN 37208
L. Suber
Affiliation:
Center for Photonic Materials and Devices, Department of Physics, Fisk University, Nashville, TN 37208
S. Wilson
Affiliation:
Center for Photonic Materials and Devices, Department of Physics, Fisk University, Nashville, TN 37208
J. Henderson
Affiliation:
Center for Photonic Materials and Devices, Department of Physics, Fisk University, Nashville, TN 37208
G. W. Wright
Affiliation:
Center for Photonic Materials and Devices, Department of Physics, Fisk University, Nashville, TN 37208
M. L. Cole
Affiliation:
Center for Photonic Materials and Devices, Department of Physics, Fisk University, Nashville, TN 37208
Get access

Abstract

Lead iodide starting materials have been purified by vertical zone refining process. The purest materials of the zone-refined ingot, middle zone, were used for single crystal growth by Bridgman method. Differential scanning calorimetry, current-voltage and low temperature photoluminescence measurements were employed to investigate the effectness of zone refining process and as-grown crystal. The results showed that the materials from the middle section of zone-refined ingot is the purest, followed by first-to-freeze and last-to-freeze materials. No second phase and deviation from stoichiometry have been observed after zone refining process and Bridgman crystal growth method. The resistivities increase as the purity and crystallinity of materials increases. Cleavage of as-grown crystal did damage the surface and caused additional emission at 2.0 eV. This emission band was not observed after a 10% NaI solution etching.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 487: Symposium I – Semiconductors for Room-Temperature Radiation II , 1997 , 369
Copyright
Copyright © Materials Research Society 1998

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

[1] Roth, S. and Willing, W. R., Appl. Phys. Lett. 18, p. 328 (1971).Google Scholar
[2] Manfredotti, C., Mumri, R., Quirini, A. and Vasanelli, L., IEEE Trans. Nucl. Sci. NS–24, p. 126 (1977).Google Scholar
[3] Lund, J. C., Shah, K. S., Squillante, M. R. and Sinclair, F., IEEE Trans. Nucl. Sci. NS–35, p. 89 (1988).Google Scholar
[4] Lund, J. C., Shah, K. S., Squillante, M. R., Moy, L. P., Sinclair, F. and Entine, G., Nucl. Inst. And Meth. A 283, p. 299 (1989).Google Scholar
[5] Lund, J. C., Shah, K. S., Olschner, F., Zhang, J., Moy, L. P., Medrick, and R.Squillante, M., Nucl. Inst. And Meth. A 322, p. 464 (1992).Google Scholar
[6] Zhang, J., Shah, K. S., Olschner, F Lund, J. C., Moy, L. P., Daley, K., Cirignano, L. and Squillante, M. R., Nucl. Instr. And Meth. A 322, p. 499 (1992).Google Scholar
[7] Dominique, D. C., James, R. B. Feemster, H., Anderson, R., Antolak, A. J., Morse, D. H., Pontau, A. E., Jayatirtha, H., Burger, A., Bao, X. J., Schlesinger, T. E., Bench, G. S. and Heikkinen, D. W., Mat. Res. Sym. Proc. 302, p. 335 (1993).Google Scholar
[8] Schlesinger, T. E., James, R. B., Schieber, M., Toney, J., Van Scyoc, J. M., Salary, L., Hermon, H., Lund, J., Burger, A., Chen, K.-T., Cross, E., Soria, E., Shah, K., Squillante, M., Yoon, H. and Goorsky, M., Nucl. Instr. And Meth. A 380, p. 193 (1996).Google Scholar
[9] Chen, K.-T., Shi, D., Morgan, S. H., Collins, W. E. and Burger, A., Proceeding of NASA University Research Centers (URC-TC '97), edited by Jamahidi, M et al., 1, p. 157, February, Albuquerque, New Mexico (1997).Google Scholar
[10] Chen, H., Tong, J., Shi, D. T., Wu, G. H., Chen, K.-T., George, M. A., Collins, W.E., Burger, A., James, R. B., Stahle, C. M. and Bartlett, L. M., J. Appl. Phys. 80 (5), p.1 (1996).Google Scholar
[11] Brodin, M. S., Gushcha, A. O., Taranenko, L. V., Tishchenko, V. V., Khotyaintsev, V. N., Shevel, S. G., Soy. Phys. Solid State 28, p. 1658 (1986).Google Scholar