Skip to main content Accessibility help

Photoluminescence imaging for quality control in silicon solar cell manufacturing

  • Daniel Chung (a1), Bernhard Mitchell (a1), Jürgen W. Weber (a2), Neil Yager (a2) and Thorsten Trupke (a1) (a2)...


We report on progress with PL imaging applications in silicon solar cell production, specifically focusing on the characterization of silicon bricks prior to wafer cutting. Silicon bricks represent an ideal opportunity to characterize and quantify the electronic material quality at an early stage of the PV value chain. Quantitative data on bulk lifetime can be obtained on bricks without any specific sample preparation, unlike unprocessed wafers. Spatially resolved bulk lifetime, interstitial iron concentration, and defect density measurements are demonstrated on bricks from different manufacturers including both high performance multicrystalline and older generation multicrystalline bricks. We find significant variability in bulk lifetime and iron concentration across the samples which is not related to its date of manufacture. However we do see a qualitative reduction in crystallographic defects in the newer high performance multicrystalline bricks. Data is parameterized in different ways to suggest possible paths to better predict solar cell efficiencies from an early stage of inspection.

Brick level PL measurements were previously performed using a conventional area scanning PL imaging system, which is associated with light spreading artefacts of weakly absorbed light. To overcome these artefacts, a new line scanning photoluminescence imaging system is used. We show a reduction in contrast smearing between high- and low lifetime regions in the new setup leading to image quality suitable for defect detection and quantitative measurements without deconvolution correction.


Corresponding author


Hide All
[1] Fraunhofer ISE, “2015 Photovoltaics Report,” 2015. [Online]. Available: [Accessed: 16-Aug-2015].
[2] Zhang, X., Gong, L., Wu, B., Zhou, M., and Dai, B., “Characteristics and value enhancement of cast silicon ingots,” Sol. Energy Mater. Sol. Cells, vol. 139, pp. 2733, 2015.
[3] Mitchell, B., Trupke, T., Weber, J. W., and Nyhus, J., “Bulk minority carrier lifetimes and doping of silicon bricks from photoluminescence intensity ratios,” J. Appl. Phys., vol. 109, no. 2011, pp. 012, 2011.
[4] Wagner, H., Hofstetter, J., Mitchell, B., Altermatt, P. P., and Buonassisi, T., “Device architecture and lifetime requirements for high efficiency multicrystalline silicon solar cells,” Energy Procedia, vol. 77, pp. 225230, 2015.
[5] Green, M. A., “The Passivated Emitter and Rear Cell (PERC): From conception to mass production,” Sol. Energy Mater. Sol. Cells, vol. 143, pp. 190197, Dec. 2015.
[6] Hofstetter, J., Fenning, D. P., Powell, D. M., Morishige, A. E., and Wagner, H., “Sorting Metrics for Customized Phosphorus Diffusion Gettering,” IEEE J. Photovoltaics, vol. 4, no. 6, pp. 14211428, 2014.
[7] Mitchell, B., Weber, J. W., Walter, D., Macdonald, D., and Trupke, T., “On the method of photoluminescence spectral intensity ratio imaging of silicon bricks: Advances and limitations,” J. Appl. Phys., vol. 112, pp. 013, 2012.
[8] Zoth, G. and Bergholz, W., “A fast, preparation-free method to detect iron in silicon,” J. Appl. Phys., vol. 67, no. 11, pp. 67646771, 1990.
[9] Mitchell, B., Macdonald, D., Schon, J., Weber, J. W., Wagner, H., and Trupke, T., “Imaging As-Grown Interstitial Iron Concentration on Boron-Doped Silicon Bricks via Spectral Photoluminescence,” IEEE J. Photovoltaics, vol. 4, no. 5, pp. 11851196, 2014.
[10] Bowden, S. and Sinton, R. A., “Determining lifetime in silicon blocks and wafers with accurate expressions for carrier density,” J. Appl. Phys., vol. 102, no. 2007, 2007.
[11] Carnel, L., Hjemås, P. C., Lu, T., Nyhus, J., Helland, K., and Gjerstad, , “Influence of wafer quality on cell performance,” Conf. Rec. IEEE Photovolt. Spec. Conf., pp. 000036000038, 2009.
[12] You, D., Du, J., Zhang, T., Wan, Y., Shan, W., Wang, L., and Yang, D., “The dislocation distribution characteristics of a multi-crystalline silicon ingot and its impact on the cell efficiency,” in Conference Record of the IEEE Photovoltaic Specialists Conference, 2010, pp. 22582261.
[13] Fu, S., Xiong, Z., Feng, Z., Verlinden, P. J., and Huang, Q., “Cell performance prediction based on the wafer quality,” Energy Procedia, vol. 38, no. DECEMBER, pp. 4348, 2013.
[14] Gibaja, F., Bartel, T., Heuer, M., Graf, O., Kaes, M., and Kirscht, F., “Silicon ingot quality and resulting solar cell performance,” Energy Procedia, vol. 38, pp. 551560, 2013.
[15] Yang, Y. M., Yu, A., Hsu, B., Hsu, W. C., Yang, A., and Lan, C. W., “Development of high-performance multicrystalline silicon for photovoltaic industry,” Progress in Photovoltaics: Research and Applications, vol. 20, no. 1, pp. 611, 2013.
[16] Schubert, M. C., Schon, J., Schindler, F., Kwapil, W., Abdollahinia, A., Michl, B., Riepe, S., Schmid, C., Schumann, M., Meyer, S., and Warta, W., “Impact of impurities from crucible and coating on mc-silicon quality-The example of iron and cobalt,” IEEE J. Photovoltaics, vol. 3, no. 4, pp. 12501258, 2013.
[17] Macdonald, D., Cuevas, A., Kinomura, a., Nakano, Y., and Geerligs, L. J., “Transition-metal profiles in a multicrystalline silicon ingot,” J. Appl. Phys., vol. 97, no. 3, 2005.
[18] Zhong, G., Yu, Q., Huang, X., and Liu, L., “Influencing factors on the formation of the low minority carrier lifetime zone at the bottom of seed-assisted cast ingots,” J. Cryst. Growth, vol. 402, pp. 6570, 2014.
[19] Lan, C. W., Yang, Y. M., Yu, a., Wu, Y. C., Hsu, B., Hsu, W. C., and Yang, a., “Recent Progress of Crystal Growth Technology for Multi-Crystalline Silicon Solar Ingot,” Solid State Phenom., vol. 242, pp. 2129, 2015.
[20] Laurent, J., Enjalbert, N., Drevet, B., Jouini, A., and Martin, C., “Crucible contribution to cell efficiency and process yield,” 31st Eur. Photovolt. Sol. Energy Conf. Exhib., 2015.


Related content

Powered by UNSILO

Photoluminescence imaging for quality control in silicon solar cell manufacturing

  • Daniel Chung (a1), Bernhard Mitchell (a1), Jürgen W. Weber (a2), Neil Yager (a2) and Thorsten Trupke (a1) (a2)...


Full text views

Total number of HTML views: 0
Total number of PDF views: 0 *
Loading metrics...

Abstract views

Total abstract views: 0 *
Loading metrics...

* Views captured on Cambridge Core between <date>. This data will be updated every 24 hours.

Usage data cannot currently be displayed.