Article contents
Phases in the Al-Corner of the Al–Mn–Be System
Published online by Cambridge University Press: 18 June 2013
Abstract
This work studied the phases in the Al corner of the Al–Mn–Be phase diagram in the as-cast state and heat-treated conditions. Metallographic investigations, X-ray diffraction, scanning electron microscopy, and energy-dispersive spectroscopy were used for identifying the phases. The Be contents in the identified phases were precisely determined using Auger electron spectroscopy. The results indicated that Al6Mn does not dissolve Be, whilst λ-Al4Mn dissolves up to 7 at.% Be. The average composition of the T phase, which is normally designated as Al15Mn3Be2, was 72 at.% Al, 19 at.% Mn, and 9 at.% Be. The phase with the nominal composition Be4AlMn contained more Al than Mn. The atomic ratio Al:Mn was between 1.3:1 and 2:1. The hexagonal Be-rich phase did not dissolve any Al and Mn. The icosahedral quasicrystalline (IQC) phase contained up to 45 at.% Be. The compositions of T phase, λ–Al4Mn, IQC, and Be4AlMn may vary, however, the ratio (Al + Be):Mn remained constant, and was close either to four or six indicating substitution of Al atoms with Be atoms in these phases.
- Type
- Materials Applications
- Information
- Copyright
- Copyright © Microscopy Society of America 2013
References
- 8
- Cited by