Rare-earth intermetallic compounds adopting the tetragonal ThMn12–type structure and containing high Fe concentrations have attracted considerable attention in the field of permanent magnets. Among them, the Y-Fe-Mo series has been extensively investigated, especially by X-ray diffraction (XRD), but the microstructural characterization was very limited.

In the present work, Y:11Fe:Mo has been prepared by melting Y, Fe and Mo in an arc furnace followed by splat-quenching and/or annealing treatments. The structure, chemistry and magnetic domain configurations of the resulting polycrystalline aggregates have been investigated by XRD, scanning and transmission electron microscopies (SEM and TEM, respectively), energy dispersive X-ray spectroscopy (EDS) and Lorentz microscopy.

A special emphasis was given to Lorentz microscopy, where contrast is based on the Lorentz deflection imposed on electrons by the passage through a magnetic specimen. The magnetic domains have been imaged by the intermediate lens in Fresnel mode, with the objective lens switched off. In these conditions the intermediate lens is defocused so that out-of-focus images of the specimen are formed: the magnetic domain walls are imaged as alternate bright (convergent) and dark (divergent) lines. For the overfocused image, bright lines occur at the position of domain walls for which the magnetisation on either side is deflecting the electrons towards the wall, whereas dark lines are observed at the walls for which the magnetisation on either side is deflecting the electrons away from the wall. The opposite contrast is observed at the underfocused image.

The results have shown that the tetragonal YFe11-xMoy phase is predominant, with a cellular dendritic morphology (Figure 1), but a considerable presence of -Fe(Mo) could be inferred, forming a coarse intercellular eutectic mixture. Significant Fe segregation occurred during annealing. However, this composition variation corresponded to an extremely limited evolution of the lattice parameters, the Rietveld analysis pointing to Fe vacancies at the 8i sites on the annealed material. XRD and EDS results indicate that the fraction of point defects in the ThMn12-type structure adapts to the processing route and that the stable configuration depends on the temperature. The current study also showed that grain boundaries are usually associated with domain walls and that YFe11Mo grains present internal domain walls forming stripe/maze patterns characteristic of high anisotropy materials (Figure 2), while residual -Fe(Mo) grains exhibit vortex configurations (see arrows in Figures 2 (a-c)).

The work was supported by the Portuguese Science Foundation through the CTM/48617/2002 and PEst-OE/CTM-UI0084/2011 grants.