Hostname: page-component-8448b6f56d-sxzjt Total loading time: 0 Render date: 2024-04-18T14:33:30.019Z Has data issue: false hasContentIssue false
  • English
  • Français

Low voltage, low energy, and repetitive (4 Hz) operation of a conventional vircator for microwave emission in the range of 4–8 GHz

Published online by Cambridge University Press:  30 August 2013

Rohit Shukla  and
Anurag Shyam
Rohit Shukla*
Affiliation:
Energetics and Electromagnetics Division, Electronics and Instrumentation Group, Bhabha Atomic Research Centre Facility, Visakhapatanam, India
Anurag Shyam
Affiliation:
Energetics and Electromagnetics Division, Electronics and Instrumentation Group, Bhabha Atomic Research Centre Facility, Visakhapatanam, India
*
Address correspondence and reprint requests to: Rohit Shukla, Energetics and Electromagnetics Division, Electronics and Instrumentation Group, Bhabha Atomic Research Centre Facility, Visakhapatanam, APIndia. E-mail: rshukla@barc.gov.in
Get access Rights & Permissions [Opens in a new window]

Abstract

In this paper, we are presenting the microwave emission results of a vircator that emits its radiation lying well-within the microwave range of electromagnetic spectrum viz 4–8 GHz and the energy needed per shot is as low as 25 Joules only. In this reported experiment, the pulse forming line is charged to a voltage of 160 kV and the measured diode voltage is 50 kV in the experiment. The primary energy is nearly 50 Joules only and hence the energy efficiency of the high voltage pulse transformer and pulse forming line combination for the given experiment is nearly 50%. The experiment is the first of its kind in establishing (experimentally) the low voltage operation of a conventional vircator, which has a planar cylindrical cathode and stainless steel mesh anode, for the microwave emission purpose. Moreover, because of the low voltage and low energy operation we could operate the whole system in repetitive mode and we could achieve as high as 4 Hz operation with this device. Interestingly, the current density of the velvet cathode used in the present experiment is nearly 300 A/cm2 in the present reported set of experiments. One interesting observation emerging out from the present experiment is that in the low voltage operation of the vircator the beam acceleration potential is relatively low and hence the axial velocities of reflexing electrons (trapped between cathode and virtual cathode) is also limited and far less than 1.8 × 108 m/s and hence with small anode cathode gaps like that of 3 mm, which is the case of present experiments, it becomes feasible to achieve radiation frequency of 4–8 GHz from the vircator.

Keywords

Compact pulsed powerHigh power microwaveParticle in cellVirtual cathodeOscillator
Type
Research Article
Information
Laser and Particle Beams , Volume 31 , Issue 4 , December 2013 , pp. 627 - 634
Copyright
Copyright © Cambridge University Press 2013 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Betzios, P.V., Uzunoglu, N.K. (2009). Investigation of the dynamic behaviour of a vircator based on an analytical model and experimental observations. Microwave Rev. Mikrotalasna revija 15, 24–28.Google Scholar
Chen, Y., Mankowski, J., Walter, J., Kristiansen, M. & Gale, R. (2007). Cathode and anode optimization in a virtual cathode oscillator. IEEE Trans. Dielectr. Electr. Insul. 14, 1037–1044.CrossRefGoogle Scholar
Choi, E.H., Choi, M.C., Choi, S.H., Song, K.B., Jung, Y., Seo, Y.H., Shin, H.M., Uhm, H.S., Lim, D.W., Kim, C.H., Lee, J.M. & Ahn, J.W. (2002). Characteristics of diode perveance and vircator output under various anode-cathode gap distances. IEEE Trans. Plasma Sci. 30, 1728–1732.CrossRefGoogle Scholar
Choi, E.-H., Choi, M.C., Jung, Y., Chong, M.W., Ko, J.J., Seo, Y., Cho, G., Uhm, H.S. & Suk, H. (2000). High-power microwave generation from an axially extracted virtual cathode oscillator. IEEE Trans. Plasma Sci. 28, 2128–2134.CrossRefGoogle Scholar
Egorov, E.N., Kalinin, Yu.A., Koronovskii, A.A., Hramov, A.E. & Morozov, M.V. (2006). Microwave generation power in a nonrelativistic electron beam with virtual cathode in a retarding electric field. Techn. Phys. Lett. 32, 402–405.CrossRefGoogle Scholar
Egorov, E.N., Kalinin, Yu.A., Koronovskii, A.A. & Hramov, A.E. (2007). Analysis of the dependence of the microwave generation power of a low-voltage vircator on controlling parameters. Techn. Phys. 52, 1387–1390.CrossRefGoogle Scholar
Filatov, R.A., Hramov, A.E., Bliokh, Y.P., Koronovskii, A.A. & Felsteiner, J. (2009). Influence of background gas ionization on oscillations in a virtual cathode with a retarding potential Phys. Plasma doi:10.1063/1.3080200.CrossRefGoogle Scholar
Filatov, R.A., Kalinin, Yu.A., Khramov, A.E. & Trubetskov, D.I. (2006). Influence of positive ions on oscillatory processes in an electron beam with virtual cathode. Radiophys. Quan. Electr. 49, 769.Google Scholar
Filatov, R.A., Koronovskii, A.A., Kurkin, S.A. & Hramov, A.E. (2012). Dynamics of an electron beam with a virtual cathode in a vircator without a magnetic field with drift space filled by neutral gas. Phys. Bull. Russian Acad. Sci. 76, 1336–1338.CrossRefGoogle Scholar
Kalinin, Yu.A. & Starodubov, A.V. (2011). Experimental study of the effect of external noise-like signal on the dynamics of vircator with magnetron injection gun. Techn. Phys. Lett. 37, 1104–1105.CrossRefGoogle Scholar
Kurkin, S.A., Koronovskii, A.A. & Hramov, A.E. (2011). Output microwave radiation power of low-voltage vircator with external inhomogeneous magnetic field. Techn. Phys. Lett. 37, 356–359.CrossRefGoogle Scholar
Kurkin, S.A., Hramov, A.E. & Koronovskii, A.A. (2011). Chaotic signal generation in low-voltage vircator with electron source shielded from external magnetic field. Techn. Phys. Lett. 37, 144–147.CrossRefGoogle Scholar
Li, L.M., Liu, L., Xu, Q.F., Chen, G.X., Chang, L., Wan, H. & Wen, J.C. (2009). Relativistic electron beam source with uniform high-density emitters by pulsed power generators. Laser Part. Beams 27, 335–344.CrossRefGoogle Scholar
Li, L.M., Chang, L., Zhang, L., Liu, J., Chen, G. & Wen, J. (2012). Development mechanism of cathode surface plasmas of high current pulsed electron beam sources for microwave irradiation generation. Laser Part. Beams 30, 541–551.CrossRefGoogle Scholar
Roy, A., Menon, R., Sharma, V., Patel, A., Sharma, A. & Chakravarthy, D.P. (2013). Features of 200 kV, 300 ns reflex triode vircator operation for different explosive emission cathodes. Laser Part. Beams 31, 45–54.CrossRefGoogle Scholar
Singh, G. & Chaturvedi, S. (2008). Secondary virtual-cathode formation in a low-voltage vircator: PIC Simulations. IEEE Trans. Plasma Sci. 36, 694–700.CrossRefGoogle Scholar
Shukla, R., Banerjee, P., Sharma, S.K., Das, R., Deb, P., Prabaharan, T., Das, B., Adhikary, B., Verma, R. & Shyam, A. (2011). Review of scientific instruments; Note: Compact high voltage pulse transformer made using a capacitor bank assembled in the shape of primary 82. 106103 http://dx.doi.org/10.1063/1.3648119.CrossRefGoogle Scholar
Truchi, P.J. & Peterkin, R.E. (1998). Modeling of impedance collapse in high-voltage diodes. IEEE Trans. Plasma Sci. 26, 1485–1491.CrossRefGoogle Scholar
Yatsuzuka, M., Nakayama, M., Tanigawa, M., Nobuhara, S., Young, D. & Ishihara, O. (1998). Plasma effects on electron beam focusing and microwave emission in a virtual cathode oscillator. IEEE Trans. Plasma Sci. 26, 1314–1321.CrossRefGoogle Scholar