Hostname: page-component-8448b6f56d-qsmjn Total loading time: 0 Render date: 2024-04-19T20:40:37.077Z Has data issue: false hasContentIssue false
  • English
  • Français

Langmuir probe studies of laser ablated ruby plasma and correlation with pulsed laser deposited ruby thin film properties

Published online by Cambridge University Press:  06 June 2014

Satchi Kumari  and
Alika Khare
Satchi Kumari
Affiliation:
Laser and Photonics Laboratory, Department of Physics, Indian Institute of Technology Guwahati, Guwahati, India
Alika Khare*
Affiliation:
Laser and Photonics Laboratory, Department of Physics, Indian Institute of Technology Guwahati, Guwahati, India
*
Address correspondence and reprint requests to: Alika Khare, Laser and Photonics Laboratory, Department of Physics, Indian Institute of Technology Guwahati, Guwahati-781039, India. E-mail: alika@iitg.ernet.in
Get access Rights & Permissions [Opens in a new window]

Abstract

In the present paper, measurement of various plasma parameters during pulsed laser deposition of ruby thin film on quartz substrate is reported. The variation of electron temperature and ion density with laser fluence and ambient pressure is recorded via Langmuir probe technique. The structural and optical properties of ruby thin films were analyzed using photo-luminescence and atomic force microscopy, and then correlated with the plasma parameters to find optimum conditions for deposition of high quality ruby thin film.

Keywords

Laser ablationLangmuir probeRuby (Al2O3:Cr3+)Thin filmPulsed laser deposition
Type
Research Article
Information
Laser and Particle Beams , Volume 32 , Issue 3 , September 2014 , pp. 359 - 367
Copyright
Copyright © Cambridge University Press 2014 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Aizawa, H., Ohishi, N., Ogawa, S., Katsumata, T. & Komuro, S. (2002). Fabrication of ruby sensor probe for the fiber-optic thermometer using fluorescence decay. Rev. Sci. Instrum. 73, 3656–3658.CrossRefGoogle Scholar
Aizawa, H., Shibasaki, M., Komuro, S., Miyazaki, Y. & Katsumata, T. (2009). Fabrication of ruby thin film for temperature indicator application. International Conference on Electrical Engineering.Google Scholar
Bigelow, M.S., Lepeshkin, N.N. & Boyd, R.W. (2003). Observation of ultraslow light propagation in a ruby crystal at room temperature. Phy. Rev. Lett. 90, 1139031.CrossRefGoogle Scholar
Cronemeyer, D.C. (1966). Optical absorption characteristics of pink ruby. J. Opt. Soc. Am. 56, 1703–1706.CrossRefGoogle Scholar
Cracium, V., Amirhaghi, S., Cracium, D., Elders, J., Gardeniers, J.G.E. & Boyd, I.W. (1995). Effects of laser wavelength and fluence on the growth of ZnO thin films by pulsed laser deposition. Appl. Surf. Sci. 86, 99–106.CrossRefGoogle Scholar
Duan, W., Paiva, Renata M., Wentzcovitch, M. & Fazzio, A. (1997). Ruby's optical transitions: effects of pressure-induced phase transformation. Mat. Res. Soc. Symp. Proc. 499, 275.CrossRefGoogle Scholar
Gibson, U.J. & Chernuschenko, M. (1999). Ruby films as surface temperature and pressure sensors. Opt. Express 4, 443–448.CrossRefGoogle ScholarPubMed
Gao, F., Xu, J., Zhang, G., Bo, F. & Liu, H. (2008). Paraxial energy transport of a focused Gaussian beam in ruby with non-degenerate two-wave coupling like mechanism. Appl. Phys. Lett. 92, 021121.CrossRefGoogle Scholar
Gurlui, S., Agop, M., Nica, P., Ziskind, M. & Focsa, C. (2008). Experimental and theoretical investigation of a laser-produced aluminum plasma. Phys. Rev. E 78, 026405.CrossRefGoogle ScholarPubMed
Harilal, S.S., Bindhu, C.V., Issac, R.C., Nampoori, V.P.N. & Vallabhan, C.P.G. (1997). Electron density and temperature measurement in a laser produced carbon plasma. J. Appl. Phys. 82, 2140–2146.CrossRefGoogle Scholar
Harilal, S.S., Bindhu, C.V., Nampoori, V.P.N. & Vallabhan, C.P.G. (1998). Influence of ambient gas on the temperature and density of laser produced carbon plasma. Appl. Phys. Lett. 72,167–169.CrossRefGoogle Scholar
Kumari, S. & Khare, A. (2013). Optical and structural characterization of pulsed laser deposited ruby thin films for temperature sensing application. Appl. Surf. Sci. 265, 180.CrossRefGoogle Scholar
Kumari, S. & Khare, A. (2011). Epitaxial ruby thin film based photonic sensor for temperature measurement. Rev. Sci. Instrum. 82, 066106.CrossRefGoogle ScholarPubMed
Kamlesh, A. & Khare, A. (2005). Low-energy low-divergence pulsed indium atomic beam by laser ablation. Laser Part. Beams 24, 47.Google Scholar
Kamlesh, A. & Khare, A. (2006). Sculpted pulsed indium atomic beams via selective laser ablation of thin film. Laser Part. Beams 24, 469.Google Scholar
Lorusso, A., Fasano, V., Perrone, A. & Lovchinov, K. (2001). Y thin films grown by pulsed laser ablation. J. Vac. Sci. Technol. A 29, 031502.CrossRefGoogle Scholar
Maiman, T.H. (1960). Stimulated optical radiation in ruby. Nat. 187, 493.CrossRefGoogle Scholar
Mostako, A.T.T. & Khare, A. (2012). Molybdenum thin films via pulsed laser deposition technique for first mirror application. Laser Part. Beams 30, 559–567.CrossRefGoogle Scholar
Nelson, D.F. & Sturge, M.D. (1965). Relation between absorption and emission in the region of the R lines of ruby. Phy. Rev. A 137, 1117.CrossRefGoogle Scholar
Nica, P., Agop, M., Gurlui, S. & Focsa, C. (2010). Oscillatory Langmuir probe ion current in laser-produced plasma expansion. EPL 89, 65001.CrossRefGoogle Scholar
Powell, R.C. (1998). Physics of Solid State Laser Engineering. Washington, DC: AIP Press.Google Scholar
Ragan, D.D., Gustavsen, R. & Schiferl, D. (1992). Calibration of the ruby R1 and R2 fluorescence shifts as a function of temperature from 0 to 600 K. J. Appl. Phys. 72, 5539–5544.CrossRefGoogle Scholar
Shukla, G. & Khare, A. (2010). Spectroscopic studies of laser ablated ZnO plasma and correlation with pulsed laser deposited ZnO thin film properties. Laser Part. Beams 28, 149–155.CrossRefGoogle Scholar
Sankur, H. (1986). Properties of thin PbF2 films deposited by cw and pulsed laser assisted evaporation. Appl. Opt. 25, 1962–1965.CrossRefGoogle ScholarPubMed
Yu, N., Wen, Q., Clarke, D.R., Mclntyre, P.C., Kung, H., Nastasi, M., Simpson, T.W., Mitchell, I.V. & Li, D. (1995). Formation of iron or chromium doped epitaxial sapphire thin films on sapphire substrates. J. Appl. Phys. 78, 5412–5421.CrossRefGoogle Scholar
Wen, Q., Clarke, D.R., Yu, N. & Nastasi, M. (1995). Epitaxial regrowth of ruby on sapphire for an integrated thin film stress sensor. Appl. Phys. Lett. 66, 293–295.CrossRefGoogle Scholar
Wang, Y.L., Chen, C., Ding, X.C., Chu, L.Z., Deng, Z.C., Liang, W.H., Chen, J.Z. & FU, G.S. (2011). Nucleation and growth of nanoparticles during pulsed laser deposition in an ambient gas. Laser Part. Beams 29, 105–111.CrossRefGoogle Scholar
Wolowski, J., Badziak, J., Czarnecka, A., Parys, P., Pisarek, M., Rosinski, Turan R. & Yerci, S. (2007). Application of pulsed laser deposition and laser-induced ion implantation for formation of semiconductor nano-crystallites. Laser Part. Beams 25, 65–69.CrossRefGoogle Scholar
Wang, C., Cheng, B.L., Wang, S.Y., Lu, H.B., Zhou, Y.L., Chen, Z.H. & Yang, G.Z. (2005). Effects of oxygen pressure on lattice parameter, orientation, surface morphology and deposition rate of (Ba0.02Sr0.98)TiO3 thin films grown on MgO substrate by pulsed laser deposition. Thin Solid Films 485, 82–89.CrossRefGoogle Scholar