1.Ekinci, K. L., “Electromechanical Transducers at the Nanoscale: Actuation and Sensing of Motion in Nanoelectromechanical Systems (NEMS),” Small, 1, pp. 786–797 (2005).
2.Xu, Y., Lin, J. T., Alphenaar, B. W. and Keynton, R. S., “Viscous Damping of Microresonators for Gas Composition Analysis,” Applied Physics Letters, 88, 143513 (2006).
3.Beek, J. T. M. V. and Puers, R., “A Review of MEMS Oscillators for Frequency Reference and Timing Applications,” Journal of Micromechanics and Microengineering, 22, 013001 (2012).
4.Li, M., Tang, H. X. and Roukes, M., “Ultra-Sensitive NEMS-Based Cantilevers for Sensing, Scanned Probe and Very High-Frequency Applications,” Nature Nanotechnology, 2, pp. 114–120 (2007).
5.Connell, A. D. O. et al., “Quantum Ground State and Single-Phonon Control of a Mechanical Resonator,” Nature, 464, pp. 697–703 (2010).
6.Liu, X. et al., “On the Modes and Loss Mechanisms of a High Q Mechanical Oscillator,” Applied Physics Letters, 78, 1346 (2001).
7.Bao, M. and Yang, H., “Squeeze Film Air Damping in MEMS,” Sensors and Actuators. A, Physical, 136, pp. 3–27 (2007).
8.Photiadis, D. M. and Judge, J. A., “Attachement Losses of High Q Oscillators,” Applied Physics Letters, 85, pp. 482–484 (2004).
9.Yi, Y. B. and Matin, M. A., “Eigenvalue Solution of Thermoelastic Damping in Beam Resonators Using a Finite Element Analysis,” Journal of Vibration and Acoustics, 129, pp. 478–483 (2007).
10.Zener, C., “Internal Friction in Solids, I: Theory of Internal Friction in Reeds,” Physical Review, 52, pp. 230–235 (1937).
11.Lifshitz, R. and Roukes, M. L., “Thermoelastic Damping in Micro- and Nanomechanical Systems,” Physical Review B, 61, pp. 5600–5609 (2000).
12.Mohammadi, A. K. and Ali, N. A., “Vibrational Behavior of an Electrically Actuated Micro-Beam with Thermoelastic Damping,” Journal of Mechanics, 30, pp. 219–227 (2014).
13.Evoy, S. et al., “Temperature-Dependent Internal Friction in Silicon Nanoelectromechanical Systems,” Applied Physics Letters, 77, 2397 (2000).
14.Guo, X., Yi, Y. B. and Pourkamali, S., “A Finite Element Analysis of Thermoelastic Damping in Vented MEMS Beam Resonators,” International Journal of Mechanical Sciences, 74, pp. 73–82 (2013).
15.Candler, R. N. et al., “Impact of Slot Location on Thermoelastic Dissipation in Micromechanical Resonators,” Transducers ’05, pp. 597–600 (2005).
16.Lake, J., Duwel, A. and Candler, R. N., “Particle Swarm Optimization for Design of Slotted MEMS Resonators with Low Thermoelastic Dissipation,” Journal of Microelectromechanical Systems, 23, pp. 364–371 (2013).
17.Prabhakar, S. and Vengallatore, S., “Thermoelastic Damping in Hollow and Slotted Microresonators,” Journal of Microelectromechanical Systems, 18, pp. 725–735 (2009).
18.Guo, X. and Yi, Y. B., “Suppression of Thermoelas-tic Damping in MEMS Beam Resonators by Piezo-resistivity,” Journal of Vibration and Acoustics, 333, pp. 1079–1095 (2014).
19.Doolin, C., Kim, P. H., Hauer, B. D., MacDonald, A. J. R. and Davis, J. P., “Multidimensional Optomechanical Cantilevers for High-Frequency Force Sensing,” NeW Journal of Physics, 16, 035001 (2014).
21.Hao, Z., Erbil, A. and Ayazi, F., “An Analytical Model for Support Loss in Micromachined Beam Resonators with In-Plane Flexural Vibrations,” Sensors and Actuators. A, 109, 156 (2003).
22.Hassani, F. A., Tsuchiya, Y. and Mizuta, H., “Optimization of Quality-Factor for In-Plane Free-Free Nanoelectromechanical Resonators,” IET Micro & Nano Letters, 18, pp. 886–889 (2013).
23.Taş, V., Olcum, S., Aksoy, M. D. and Atalar, A. “Reducing Anchor Loss in Micromechanical Exten-sional Mode Resonators,” IEEE Transactions on Ultrasonics, Ferroelectrics and Frequency Control, 57, pp. 448–454 (2010).
24.Wang, K., Wong, A. C. and Nguyen, C. T. C., “VHF Free-Free Beam High-Q Micromechanical Resonators,” Journal of Microelectromechanical Systems, 9, pp. 347–360 (2000).
25.Kotani, S., Hoang, C. M., Sasaki, T. and Hane, K., “Micromirrors Connected in Series for Low Voltage Operation in Vacuum,” Journal of Vacuum Science & Technology B, 31, pp. 42001–1-42001-6 (2013).
26.Chu, H. M. and Hane, K., “Design, Fabrication and Vacuum Operation Characteristics of Two-Dimensional Comb-drive Micro-Scanner,” Sensors and Actuators A, 165, pp. 422–430 (2011).
27.Kermany, A. R., Bennett, J. S., Brawley, G. A., Bowen, W. P. and Iacopi, F., “Factors Affecting the f x Q Product of 3C-SiC Microstrings: What is the Upper Limit for Sensitivity?,” Journal of Applied Physics, 119, 055304 (2016).
28.Duwel, A., Candler, R. N., Kenny, T. W. and Var-ghese, M., “Engineering MEMS Resonators with Low Thermoelastic Damping,” Journal of Microe-lectromechanical Systems, 15, pp. 1437–1445 (2006).
29.Ghaffari, S. et al., “Quantum Limit of Quality Factor in Silicon Micro and Nano Mechanical Resonators,” Scientific Reports, 3, 3244 (2013).