Hostname: page-component-76fb5796d-45l2p Total loading time: 0 Render date: 2024-04-25T14:37:12.568Z Has data issue: false hasContentIssue false
  • English
  • Français

The nucleation and morphology of diamond crystals and films synthesized by the combustion flame technique

Published online by Cambridge University Press:  31 January 2011

K. V. Ravi ,
C. A. Koch ,
H. S. Hu  and
A. Joshi
K. V. Ravi
Affiliation:
Lockheed Missiles and Space Company, Inc., Research and Development Division, 3251 Hanover Street, Palo Alto, California 94304
C. A. Koch
Affiliation:
Lockheed Missiles and Space Company, Inc., Research and Development Division, 3251 Hanover Street, Palo Alto, California 94304
H. S. Hu
Affiliation:
Lockheed Missiles and Space Company, Inc., Research and Development Division, 3251 Hanover Street, Palo Alto, California 94304
A. Joshi
Affiliation:
Lockheed Missiles and Space Company, Inc., Research and Development Division, 3251 Hanover Street, Palo Alto, California 94304
Get access

Abstract

The nucleation and morphology of diamond crystals and films synthesized by the use of a combustion flame have been investigated. By operating an oxy-acetylene torch in a fuel-rich mode, diamond crystals and films have been deposited on mechanically abraded molybdenum, on in situ created molybdenum carbide, and on thin diamond-like carbon (DLC) layers synthesized on molybdenum. Scanning electron microscopy, Auger and Raman spectroscopy have been used to characterize the films and crystals. Diamond is found to be uniformly deposited in the region of the substrate that intersects the inner, acetylene-rich region of the flame. The nucleation density, the growth rate, and the morphology of the diamond crystals and films are found to be strongly influenced by the surface condition of the substrate. On mechanically abraded molybdenum, abraded with 600 mesh silicon carbide, and on molybdenum carbide, well-formed cubo-octahedrons of diamond, up to 45 μm in diameter, are formed for deposition times of 90 min. Film formation is seldom observed under these conditions. To enhance nucleation, thin layers of DLC were formed on molybdenum substrates by reducing the O2/C2H2 ratio in the gas mix to ∼ 0.75 for short periods of time under 30 s. This was followed by increasing the O2/C2H2 ratio to conditions that produce diamond (an O2/C2H2 ratio of ∼ 0.9). Under these conditions the nucleation density of diamond was increased by an order of magnitude and the growth rates by about 60%, as compared to diamond deposited on abraded molybdenum and molybdenum carbide. In addition, the morphology of the diamond crystals and films was substantially affected with indications of dendritic growth. The DLC layer is effective in promoting diamond nucleation due to the high surface defect density and the high hydrogen concentration of these films. The combination of surface defects, in the form of dangling bonds, and the evolution of hydrogen from the DLC layer during the diamond deposition process, which is characterized by higher temperatures, result in a high concentration of active surface sites for diamond nucleation. The nucleation density, the distribution on the substrate, and the morphology of diamond crystals and films are not driven by the transport of reactive specie in the flame to the substrate, but rather by nucleation processes, temperature distribution across the surface, and attendant surface phenomena.

Type
Diamond and Diamond-Like Materials
Information
Journal of Materials Research , Volume 5 , Issue 11 , November 1990 , pp. 2356 - 2366
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1Proc. 1st Int. Symp. on Diamond and Diamond-Like Films, edited by Dismukes, J. P., Spear, K. E., Myerson, B. S., Ravi, K.V., Moustakas, T. D., and Yoder, M. (The Electrochemical Society, Inc., Pennington, NJ, 1989).Google Scholar
2Hirose, Y. and Kondo, N., Program and Book of Abstracts, Japan Applied Physics 1988 Spring Meeting, 434 (1988).Google Scholar
3Hirose, Y., Amanuma, S., Okada, N., and Komaki, K., Proc. 1st Int. Symp. on Diamond and Diamond-Like Films (The Electrochemical Society, Inc., Pennington, NJ, 1989), p. 80.Google Scholar
4Matsui, Y., Yuuki, A., Sahara, M., and Hirose, Y., Jpn. J. Appl. Phys. 28, 1718 (1989).CrossRefGoogle Scholar
5Hanssen, L.M., Carrington, W.A., Butler, J.E., and Snail, K.A., Mater. Lett. 7, 289 (1988).CrossRefGoogle Scholar
6Hanssen, L.M., Carrington, W.A., Oakes, D., Butler, J.E., and Snail, K. A., Reprints of Papers Presented at the 197th ACS Meeting, Dallas, TX, April 9–14 (1989).Google Scholar
7Cappelli, M. A. and Paul, P. H., J. Appl. Phys. 67, 2596 (1990).CrossRefGoogle Scholar
8Piano, L.S. and Ravi, K.V., SPIE Proceedings on Raman Scattering, Luminescence, and Spectroscopie Instrumentation in Technology 1055 (1989).Google Scholar
9Piano, L.S., Yokota, S., and Ravi, K.V., Proc. 1st Int. Symp. Diamond and Diamond-Like Films (The Electrochemical Society, Inc., Pennington, NJ, 1989), p. 380.Google Scholar
10Fujimori, N., Imai, T., and Doi, A., Vacuum 36, 99 (1986).CrossRefGoogle Scholar
11Ravi, K.V., Peters, M., Piano, L., and Pinneo, M., paper T21 presented at the SDIO/IST Diamond Technology Initiative Symposium, Crystal City, Arlington, VA (1988).Google Scholar
12Ravi, K.V., Piano, L. S., Pinneo, M., Peters, M., and Yokota, S., 1st Int. Conf. on the New Diamond Science and Technology-Tokyo, Program and Book of Abstracts, Paper 1.06 (1988).Google Scholar
13Meyer, D. E., Dillon, R. O., and Wollman, J. A., J. Vac. Sci. Tech. A 7, 2325 (1989).CrossRefGoogle Scholar
14Kobashi, K., Nishimura, K., Kawate, Y., and Horiuchi, T., Phys. Rev. B 38, 4067 (1988).CrossRefGoogle Scholar
15Ono, A., Baba, H., Funamoto, H., and Nishikawa, A., Jpn. J. Appl. Phys. 25, L803 (1986).Google Scholar
16Sandhu, G. S., Swanson, M. L., and Chu, W. K., paper presented at the Strategic Defence Initiative Organization/Innovative Science and Technology Diamond Technology Initiative Symposium, Crystal City, Arlington, VA (1989) (unpublished).Google Scholar
17Joshi, A., Nimmagadda, R., and Herrington, J., J. Vac. Sci. Tech. A 8 (3), 2137 (1990).CrossRefGoogle Scholar
18Hirose, Y. and Terasawa, Y., Jpn. J. Appl. Phys. 25, L591 (1986).CrossRefGoogle Scholar
19Mucha, J. A., Flamm, D. L., and Ibbotson, D. E., J. Appl. Phys. 65, 3448 (1989).CrossRefGoogle Scholar
20Landstrass, M.I. and Ravi, K.V., Appl. Phys. Lett. 55, 975 (1989).CrossRefGoogle Scholar
21Landstrass, M.I. and Ravi, K.V., Appl. Phys. Lett. 55, 1391 (1989).CrossRefGoogle Scholar