Hostname: page-component-8448b6f56d-c47g7 Total loading time: 0 Render date: 2024-04-25T00:29:48.116Z Has data issue: false hasContentIssue false
  • English
  • Français

Effect of excimer laser alloying of Ti on the sliding friction of AISI 304 stainless steel

Published online by Cambridge University Press:  31 January 2011

T. R. Jervis ,
J. -P. Hirvonen  and
M. Nastasi
T. R. Jervis
Affiliation:
Materials Science and Technology Division, Los Alamos National Laboratory, Los Alamos, New Mexico 87544
J. -P. Hirvonen
Affiliation:
Department of Physics, University of Helsinki, SF-00170 Helsinki, Finland
M. Nastasi
Affiliation:
Materials Science and Technology Division, Los Alamos National Laboratory, Los Alamos, New Mexico 87544
Get access

Abstract

Dry sliding friction measurements made on titanium layers evaporated on AISI 304 stainless steel in the as-deposited and excimer laser mixed form show a dependence on the film thickness and the amount of mixing. The effect of laser mixing is dependent on the incident fluence with high fluences and/or large numbers of pulses producing surfaces with poor frictional properties. The optimum total fluence depends on the thickness of the surface layer, a result consistent with thorough mixing of the alloyed layer without the surface damage that results from large numbers of pulses.

Type
Articles
Information
Journal of Materials Research , Volume 3 , Issue 6 , December 1988 , pp. 1104 - 1107
Copyright
Copyright © Materials Research Society 1988

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1Ion Beam Modification of Materials, edited by Ullrich, B. M. (North-Holland, Amsterdam, 1985).Google Scholar
2Laser Surface Treatment of Metals, edited by Draper, C. W. and Mazzoldi, P. (Martinus NijhofF, Dordrecht, 1986).CrossRefGoogle Scholar
3Follstaedt, D. M., Knapp, J. A., Pope, L. E., Yost, F. G., and Picraux, S. T., Appl. Phys. Lett. 45, 529 (1984).CrossRefGoogle Scholar
4Hirvonen, J-P., Nastasi, M., and Mayer, J. W., Appl. Phys. Lett. 51, 232 (1987).CrossRefGoogle Scholar
5Jervis, T. R., Nastasi, M., and Zocco, T. G., in Fundamentals of Beam Solid Interactions and Transient Thermal Processing, edited by Aziz, M. J., Rehn, L. E., and Stritzker, B. (Materials Research Society, Pittsburgh, PA, 1988).Google Scholar
6Carslaw, H. S. and Jaeger, J. C., Conduction of Heat in Solids (Oxford U. P., Oxford, 1959).Google Scholar
7Jervis, T. R., Frydrych, D. J., and Baer, D. R., Mater. Lett. 6, 225 (1988).CrossRefGoogle Scholar
8Fayeulle, S. and Singer, I. L. (personal communication).Google Scholar
9Jervis, T. R., Nastasi, M., Zocco, T. G., and Martin, J. A., Appl. Phys. Lett. 53, 75 (1988).CrossRefGoogle Scholar