Skip to main content Accessibility help

Effect of aging on the corrosion behavior of 6005 Al alloys in 3.5 wt% NaCl aqueous solution

  • Wenkai Li (a1), Xia Chen (a2) and Bin Chen (a3)


The effect of aging time on the corrosion behavior of 6005 Al alloys has been investigated in aerated 3.5% NaCl aqueous solution. The corrosion resistance of the alloy with different aging times is analyzed by measuring potentiodynamic polarization, electrochemical impedance spectroscopy. The surface morphology is examined by scanning electron microscopy. The results demonstrated that the corrosion resistance of the alloy in the peak-aged condition is worse than the other conditions. Accordingly, corrosion rate and the corrosion current density of the alloy reach its maximum value. An Fe-rich phase is identified as the β-Al4.5FeSi phase by atomic-resolution high angle annular dark field scanning transmission electron microscopy and energy dispersive X-ray spectroscopy mapping analyses. The β-Al4.5FeSi is wrapped slowly by the precipitates of Mg2Si from the process of the peak-aged condition to the over-aged condition. It is hypothesized that the change of corrosion behavior of the alloy may be attributed to the β-Al4.5FeSi wrapped slowly by the precipitates of Mg2Si.


Corresponding author

a)Address all correspondence to this author. e-mail:


Hide All
1.Abdel-Gaber, A.M., Abd-El-Nabey, B.A., Sidahmed, I.M., El-Zayady, A.M., and Saadawy, M.: Kinetics and thermodynamics of aluminium dissolution in 1.0 M sulphuric acid containing chloride ions. Mater. Chem. Phys. 98, 291 (2006).
2.Rosliza, R., Nik, W.B.W., Izman, S., and Prawoto, Y.: Anti-corrosive properties of natural honey on Al–Mg–Si alloy in seawater. Curr. Appl. Phys. 10, 923 (2010).
3.Rosliza, R. and Nik, W.B.W.: Improvement of corrosion resistance of AA6061 alloy by tapioca starch in seawater. Curr. Appl. Phys. 10, 221 (2010).
4.Edwards, G.A., Stiller, K., Dunlop, G.L., and Couper, M.J.: The precipitation sequence in Al–Mg–Si alloys. Acta Mater. 46, 3893 (1998).
5.Miao, W.F. and Laughlin, D.E.: Precipitation hardening in aluminum alloy 6022. Scr. Mater. 40, 873 (1999).
6.Birolia, G., Cagliotiab, G., Martini, L., and Riontino, G.: Precipitation kinetics of AA4032 and AA6082: A comparison based on DSC and TEM. Scr. Mater. 39, 197 (1998).
7.Mrówkanowotnik, G.: Influence of precipitation strenghtening process on tensile and fracture behaviour of the 6005 and 6082 alloys. Int. J. Adv. Manuf. Technol. 32, 31 (2008).
8.Chen, B., Li, C.H., He, S.C., Li, X., and Lu, C.: Corrosion behavior of 2099 Al–Li alloy in NaCl aqueous solution. J. Mater. Res. 29, 1344 (2014).
9.Prabhukhot, A.: Effect of heat treatment on hardness and corrosion behavior of 6082-T6 aluminium alloy in artificial sea water. Int. J. Mater. Sci. Eng. 3, 287 (2015).
10.Braun, R.: Investigation on microstructure and corrosion behaviour of 6XXX series aluminium alloys. Mater. Sci. Forum 519, 735 (2006).
11.Zou, Y., Chen, X., and Chen, B.: Influence of interactions between β′ precipitates and long period stacking ordered structures on corrosion behaviors of Mg–10Gd–5Y–2Zn–0.5Zr (wt%) alloy. J. Mater. Res. 33, 745 (2018).
12.Osório, W.R., Peixoto, L.C., Moutinho, D.J., Gomes, L.G., Ferreira, I.L., and Garcia, A.: Corrosion resistance of directionally solidified Al–6Cu–1Si and Al–8Cu–3Si alloys castings. Mater. Des. 32, 3832 (2011).
13.Zhang, X.L., Jiang, Z.H., Yao, Z.P., Song, Y., and Wu, Z.D.: Effects of scan rate on the potentiodynamic polarization curve obtained to determine the Tafel slopes and corrosion current density. Corros. Sci. 51, 581 (2009).
14.Zaid, B., Saidi, D., Benzaid, A., and Hadji, S.: Effects of pH and chloride concentration on pitting corrosion of AA6061 aluminum alloy. Corros. Sci. 50, 1841 (2008).
15.Osório, W.R., Peixoto, L.C., Goulart, P.R., and Garcia, A.: Electrochemical corrosion parameters of as-cast Al–Fe alloys in a NaCl solution. Corros. Sci. 52, 2979 (2010).
16.Davis, J.R.: Corrosion of Aluminum and Aluminum Alloys (ASM International, Geauga County, 1999).
17.Jingling, M.A., Wen, J., Gengxin, L.I., and Chunhua, X.V.: The corrosion behaviour of Al–Zn–In–Mg–Ti alloy in NaCl solution. Corros. Sci. 52, 534 (2010).
18.Reis, F.M., Melo, H.G.D., and Costa, I.: EIS investigation on Al 5052 alloy surface preparation for self-assembling monolayer. Electrochim. Acta 51, 1780 (2006).
19.Souto, R.M., Fernández-Mérida, L., González, S., and Scantlebury, D.J.: Comparative EIS study of different Zn-based intermediate metallic layers in coil-coated steels. Corros. Sci. 48, 1182 (2006).
20.Zhang, S.S. and Jow, T.R.: Aluminum corrosion in electrolyte of Li-ion battery. J. Power Sources 109, 458 (2002).
21.Hong, T., Sun, Y.H., and Jepson, W.P.: Study on corrosion inhibitor in large pipelines under multiphase flow using EIS. Corros. Sci. 44, 101 (2002).
22.Sobral, A.V.C., Ristow, W. Jr., Azambuja, D.S., Costa, I., and Franco, C.V.: Potentiodynamic tests and electrochemical impedance spectroscopy of injection molded 316L steel in NaCl solution. Corros. Sci. 43, 1019 (2001).
23.Zeng, F.L., Wei, Z.L., Jin-Feng, L.I., Chao-Xing, L.I., Tan, X., Zhang, Z., and Zheng, Z.Q.: Corrosion mechanism associated with Mg2Si and Si particles in Al–Mg–Si alloys. Trans. Nonferrous Metals Soc. China 21, 2559 (2011).
24.Xu, D.K., Birbilis, N., Lashansky, D., Rometsch, P.A., and Muddle, B.C.: Effect of solution treatment on the corrosion behaviour of aluminium alloy AA7150: Optimisation for corrosion resistance. Corros. Sci. 53, 217 (2011).
25.Wang, S.D., Xu, D.K., Wang, B.J., Han, E.H., and Dong, C.: Effect of corrosion attack on the fatigue behavior of an as-cast Mg–7% Gd–5% Y–1% Nd–0.5% Zr alloy. Mater. Des. 84, 185 (2015).
26.Yuan, S.J. and Pehkonen, S.O.: Surface characterization and corrosion behavior of 70/30 Cu–Ni alloy in pristine and sulfide-containing simulated seawater. Corros. Sci. 49, 1276 (2007).
27.Rømming, C., Hansen, V., and Gjønnes, J.: Crystal structure of β-Al4.5FeSi. Acta Crystallogr. B 50, 307 (1994).
28.Nikseresht, Z., Karimzadeh, F., Golozar, M., and Heidarbeigy, M.: Effect of heat treatment on microstructure and corrosion behavior of Al6061 alloy weldment. Mater. Des. 31, 2643 (2010).
29.Yasakau, K.A., Zheludkevich, M.L., Lamaka, S.V., and Ferreira, M.G.: Role of intermetallic phases in localized corrosion of AA5083. Electrochim. Acta 52, 7651 (2007).


Effect of aging on the corrosion behavior of 6005 Al alloys in 3.5 wt% NaCl aqueous solution

  • Wenkai Li (a1), Xia Chen (a2) and Bin Chen (a3)


Full text views

Total number of HTML views: 0
Total number of PDF views: 0 *
Loading metrics...

Abstract views

Total abstract views: 0 *
Loading metrics...

* Views captured on Cambridge Core between <date>. This data will be updated every 24 hours.

Usage data cannot currently be displayed