Hostname: page-component-848d4c4894-nmvwc Total loading time: 0 Render date: 2024-06-23T13:23:05.915Z Has data issue: false hasContentIssue false

Turbulence characteristics of the boundary layer on a rotating disk

Published online by Cambridge University Press:  26 April 2006

Howard S. Littell
Affiliation:
Department of Mechanical Engineering, Standford University, Standford, CA 94305, USA Present address: Shell Development Company, Houston, Texas.
John K. Eaton
Affiliation:
Department of Mechanical Engineering, Standford University, Standford, CA 94305, USA

Abstract

Measurements of the boundary layer on an effectively infinite rotating disk in a quiescent environment are described for Reynolds numbers up to Reδ2 = 6000. The mean flow properties were found to resemble a ‘typical’ three-dimensional crossflow, while some aspects of the turbulence measurements were significantly different from two-dimensional boundary layers that are turned. Notably, the ratio of the shear stress vector magnitude to the turbulent kinetic energy was found to be at a maximum near the wall, instead of being locally depressed as in a turned two-dimensional boundary layer. Also, the shear stress and the mean strain rate vectors were found to be more closely aligned than would be expected in a flow with this degree of crossflow. Two-point velocity correlation measurements exhibited strong asymmetries which are impossible in a two-dimensional boundary layer. Using conditional sampling, the velocity field surrounding strong Reynolds stress events was partially mapped. These data were studied in the light of the structural model of Robinson (1991), and a hypothesis describing the effect of cross-stream shear on Reynolds stress events is developed.

Type
Research Article
Copyright
© 1994 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Anderson, S. D. & Eaton, J. K. 1987 An experimental investigation of pressure driven three-dimensional boundary layers. Stanford Univ., Dept. Mech. Engng Thermosciences Div. Rep. MD-49.
Anderson, S. D. & Eaton, J. K. 1989 An experimental investigation of pressure-driven three-dimensional boundary layers. J. Fluid Mech. 202, 263294.Google Scholar
Berg, B. van den, Elsenaar, A., Lindhout, J. P. F. & Wesseling, P. 1975 Measurements in an incompressible three-dimensional turbulent boundary layer, under infinite swept wing conditions, and comparison with theory. J. Fluid Mech. 70, 127148.Google Scholar
Bissonnette, L. R. & Mellor, G. L. 1974 Experiments on the behaviour of an axisymmetric turbulent boundary layer with a sudden circumferential strain. J. Fluid Mech. 63, 369413.Google Scholar
Bradshaw, P. 1970 Calculation of three-dimensional turbulent boundary layers. J. Fluid Mech. 46, 417445.Google Scholar
Bradshaw, P., Ferris, D. H. & Atwell, N. P. 1967 Calculation of boundary-layer development using the turbulent energy equation. J. Fluid Mech. 28, 593616.Google Scholar
Bradshaw, P. & Pontikos, N. S. 1985 Measurements in the turbulent boundary layer on an ‘infinite’ swept wing. J. Fluid Mech. 159, 105130.Google Scholar
Bradshaw, P. & Sendstad, O. 1990 Structure of three-dimensional boundary layers. Center for Turbulence Research Proc. Summer Program, 1990.
Bradshaw, P. & Terrell, M. C. 1969 The response of a turbulent boundary layer on an ‘infinite’ swept wing to the sudden removal of pressure gradient. NPL Aero Rep. 1305.
Case, P. 1966 Measurements of entrainment by a free rotating disk. J. R. Aero. Soc. 71, 124.Google Scholar
Cebeci, T. & Abbott, D. -E. 1975 Boundary layers on a rotating disk. AIAA J. 13, 829832.Google Scholar
Cham, T.-S. & Head, M. R. 1969 Turbulent boundary-layer flow on a rotating disk. J. Fluid Mech. 37, 129147.Google Scholar
Cimbala, J. M. & Park, W. J. 1990 a direct hot-wire calibration technique to account for ambient temperature drift in incompressible flow. Exp. Fluids 8, 299300.Google Scholar
Cobb, E. C. & Saunders, O. A. 1956 Heat transfer from a rotating disk. Proc. R. Soc. Lond. A 236, 343351.Google Scholar
Coleman, G. N., Ferziger, J. H. & Spalart, P. R. 1990 A numerical study of the turbulent Ekman layer. J. Fluid Mech. 213, 313348.Google Scholar
Cutler, A. D. & Johnston, J. P. 1989 The relaxation of a turbulent boundary layer in an adverse pressure gradient. J. Fluid Mech. 200, 367387.Google Scholar
Dechow, R. & Felsch, K. O. 1977 Measurements of the mean velocity and of the Reynolds stress tensor in a three-dimensional turbulent boundary layer induced by a cylinder standing on a flat wall. Proc. 1st Turbulent Shear Flow Symp., University Park, Pennsylvania, Apr. 18-20.
Driver, D. M. & Johnston, J. P. 1990 Experimental study of a three-dimensional shear-driven turbulent boundary layer with streamwise adverse pressure gradient. NASA TM 102211; and Stanford Univ., Dept. Mech. Eng. Thermosciences Div. Rep. MD-57.
Eaton, J. K. 1991 Turbulence structure and heat transfer in three-dimensional boundary layers. Proc. 9th Symp. on Energy Engineering Sciences, Argonne Natl Lab.
Elsenaar, A. & Boelsma, S. H. 1974 Measurements of the Reynolds stress tensor in a three-dimensional turbulent boundary layer under infinite swept wing conditions. NLR TR 74095 U.
Erian, F. F. & Tong, V. H. 1971 Turbulent flow due to a rotating disk. Phys. Fluids 14, 25882591.Google Scholar
Fernholz, H. H. & Vagt, J.-D. 1981 Turbulence measurements in an adverse-pressure-gradient three-dimensional turbulent boundary layer among a circular cylinder. J. Fluid Mech. 111, 233269.Google Scholar
Goldstein, S. 1935 On the resistance to the rotation of a disk immersed in a fluid. Proc. Camb. Phil. Soc. 31, 232.Google Scholar
Grant, H. L. 1958 The large eddies of turbulent motion. J. Fluid Mech. 4, 149190.Google Scholar
Gregory, N., Stuart, J. T. & Walker, W. S. 1955 On the stability of three-dimensional boundary layers with application to the flow due to a rotating disk. Phil. Trans. R. Soc. Lond. A 248, 155199.Google Scholar
Hunt, J. C. R., Spalart, P. R. & Mansour, N. N. 1987 A general form for the dissipation length scale in turbulent shear flows. Center for Turbulence Research, Proc. Summer Program. 1987, pp. 179184.
Itoh, M., Yamada, Y., Imao, S. & Gonda, M. 1990 Experiments on turbulent flow due to an enclosed rotating disk. Intl Symp. on Turbulence Modelling and Measurements, Dubrovnik, Yugoslavia. pp. 659668.
Johnston, J. P. 1970 Measurements in a three-dimensional turbulent boundary layer induced by a swept, forward-facing step. J. Fluid Mech. 42, 823844.Google Scholar
Kármán, T. von 1921 Über Laminare und Turbulente Reibung. Z. Angew. Math. Mech. 1, 233252. (transl: On laminar and turbulent friction. NACA Tech. Mem. 1092 (1946)).Google Scholar
Klebanoff, P. S. 1954 Characteristics of turbulence in a boundary layer with zero pressure gradient. NACA TN 3178 (superseded by NACA Rep. 1247).
Kobayashi, R., Kohama, Y. & Takamadate, Ch. 1980 Spiral vortices in boundary layer transition regime on a rotating disk. Acta Mechanica 35, 7182.Google Scholar
Kohama, Y. 1987 Crossflow instability in rotating disk boundary-layer. AIAA-87-1340.
Ligrani, P. M. & Bradshaw, P. 1987 Spatial resolution and measurement of turbulence in the viscous sublayer using subminiature hot-wire probes. Exp. Fluids 5, 407417.Google Scholar
Littell, H. S. & Eaton, J. K. 1991a The unsteady flowfield behind a vortex generator rapidly pitched to angle of attack. AIAA J. 29, 577584.Google Scholar
Littell, H. S. & Eaton, J. K. 1991b An experimental investigation of the three-dimensional boundary layer on a rotating disk. Stanford Univ., Dept. Mech. Engng Thermosciences Div. Rep. MD-60.
Lohmann, R. P. 1976 The response of a developed turbulent boundary layer to local transverse surface motion. Trans. ASME I: J. Fluids Engng 98, 354363.Google Scholar
Moin, P., Shih, T.-H., Driver, D. M. & Mansour, N. N. 1990 Direct numerical simulation of a three-dimensional turbulent boundary layer. Phys. Fluids A 2, 18461853.Google Scholar
Muller, U. & Krause, B. 1979 Measurements of mean velocities and Reynolds stresses in an incompressible three-dimensional turbulent boundary layer. Proc. 2nd Turbulent Shear Flows Symp. Imperial College, London, 1979, p. 15.36.
Robinson, S. K. 1991 Motions in the turbulent boundary layer. Ann. Rev. Fluid Mech. 23, 601639.Google Scholar
Sendstad, O. & Moin, P. 1991 On the mechanics of 3-D turbulent boundary layer. Proc. 8th Turbulent Shear Flow Symp., Munich, Germany, Sept. 9-11. pp. 5-4-1–5-4-5.
Senoo, Y. & Nishi, M. 1972 Equilibrium three-dimensional turbulent boundary layer on the end wall of a curved channel. Proc. 2nd Intl JSME Symp., Tokyo, Japan, Sept. 1972. pp. 2130.
Shizawa, T. & Eaton, J. K. 1992 Turbulence measurements for a longitudinal vortex interacting with a three-dimensional turbulent boundary layer. AIAA J. 30, 4955.Google Scholar
Spalart, P. R. 1988 Direct simulation of a turbulent boundary layer up to Reθ = 1410. J. Fluid Mech. 187, 6198.Google Scholar
Spalart, P. R. 1989 Theoretical and numerical study of a three-dimensional turbulent boundary layer. J. Fluid Mech. 205, 319340.Google Scholar
Squire, H. B. & Winter, K. G. 1951 The secondary flow in a cascade of airfoils in a nonuniform stream. J. Aero. Sci. 18, 271277.Google Scholar
Theodorsen, T. & Regier, A. 1944 Experiments on drag of revolving disks, cylinders and streamline rods at high speeds. NACA Rep. 793.
Townsend, A. A. 1976 The Structure of Turbulent Shear Flow. Cambridge University Press.
Tritton, D. J. 1967 Some new correlation measurements in a turbulent boundary layer. J. Fluid Mech. 28, 439462.Google Scholar
Tutu, N. K. & Chevray, R. 1975 Cross-wire anemometry in high intensity turbulence. J. Fluid Mech. 71, 785800.Google Scholar
Westphal, R. V. & Mehta, R. D. 1985 Crossed hot-wire data acquisition and reduction system. NASA TM 85871.
Wilkinson, S. P. & Malik, M. R. 1985 Stability experiments in the flow over a rotating disk. AIAA J. 23, 588595.Google Scholar