Hostname: page-component-8448b6f56d-dnltx Total loading time: 0 Render date: 2024-04-19T20:22:44.726Z Has data issue: false hasContentIssue false
  • English
  • Français

Hot-wire and hot-film anemometry and conditional measurements: A report on Euromech 132

Published online by Cambridge University Press:  20 April 2006

G. Comte-Bellot ,
G. Charnay  and
J. Sabot
G. Comte-Bellot
Affiliation:
Ecole Centrale de Lyon, 69130 Ecully, France
G. Charnay
Affiliation:
Ecole Centrale de Lyon, 69130 Ecully, France
J. Sabot
Affiliation:
Ecole Centrale de Lyon, 69130 Ecully, France
Get access Rights & Permissions [Opens in a new window]

Abstract

The European Mechanics Colloquium, Euromech 132, was held at the Ecole Centrale de Lyon from 2 to 4 July 1980. Specific areas of hot-wire or hot-film anemometry were presented and discussed, more especially the effect of the finite time constant of the wire supports, the use of yawed hot wires in supersonic flows, the possible improvement of vorticity meters, and multi-point measurements of wall-shear-stress fluctuations. Other subjects described during the meeting included a new technique for concentration measurements in flames, developments and new uses of digitization and conditional sampling, pattern recognition analysis of fluid flow from multi-point, multi-time velocity measurements, and new turbulence measurements in complex flows and in fluid-flow machinery.

An exhibition of hot-wire and hot-film anemometers and associated equipment was held during the colloquium.

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 110 , September 1981 , pp. 115 - 128
Copyright
© 1981 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Alcaraz, E. & Mathieu, J. 1975 Mesure des vitesses moyennes près d'une paroi par anémométrie à fil chaud. C. R. Acad. Sci. Paris A 280, 737–740.Google Scholar
Baille, A. 1971 Lois de refroidissements des fils chauds aux faibles vitesses. Th. Dr. Ing. Université Aix—Marseille.
Bertoglio, J. P., Charnay, G. & Mathieu, J. 1980 Effets de la rotation sur un champ turbulent cisaillé. Application au cas des Turbomachines. J. Méc. 4, 421–443.Google Scholar
Betchov, R. 1948 L'influence de la conduction thermique sur les anémomètres à fil chaud. Proc. Ned. Akad. Wetenschappen 51, 721–730.Google Scholar
Bogar, T. J. 1975 Small scale structure in the wall region of a turbulent boundary layer. Ph.D. dissertation, Univ. of Michigan.
Bonnet, J. P. & Alziary de Roquefort, T. 1980 Determination of frequency response of constant temperature hot-wire anemometers in supersonic flows. Rev. Sci. Instrum. 51, 234–239.Google Scholar
Bradbury, L. J. S. 1976 Measurements with a pulsed-wire and a hot-wire anemometer in the highly turbulent wake of a normal flat plate. J. Fluid Mech. 77, 473–497.Google Scholar
Brison, J. F., Charnay, G. & Comte-Bellot, G. 1979 Calcul des transferts thermiques entre film chaud et substrat par un modèle à deux dimensions: prevision de la reponse dynamique de sondes usuelles. Int. J. Heat Mass Transfer 22, 111–119.Google Scholar
Carr, L. W. & Mccroskey, W. J. 1979 A directionally sensitive hot wire probe for detection of flow reversal in highly unsteady flows. ICIASF Record, pp. 154–162.
Cleveland, W. G. 1979 A constant temperature streamwise vorticity probe. M.s. Thesis, Univ. of Maryland.
Comte-Bellot, G. 1976 Hot-wire anemometry. Ann. Rev. Fluid Mech. 8, 209–231.Google Scholar
Comte-Bellot, G. 1976 Les methodes de mesure physique de la turbulence. J. Phys. Suppl. 37 (C1), 67–78.Google Scholar
Cook, N. J. & Redfearn, D. 1976 Calibration and use of a hot-wire probe for highly turbulent and reversing flows. J. Indust. Aerodyn. 1, 221–231.Google Scholar
Corrsin, S. 1963 Turbulence: experimental methods. Handbuch der Physik, 8/2, pp. 523–590.
Springer Dent, J. C. & Salama, N. S. 1975 The measurement of the turbulence characteristics in an internal combustion engine. S.A.E. Automobile Engng Meeting, Detrgoit, paper no. 750–886.
Giovanangeli, J. P. 1980 A non-dimensional heat transfer law for a slanted hot-film in water flow. DISA Inf. 25, 6–9.Google Scholar
Gottesdiener, L. 1979 Experimental study of flow near the trailing edge of a flat plate in rarefied gas. A.I.A.A. J. 17, 1159–1163.Google Scholar
Gunkel, A. A., Patel, R. P. & Weber, M. E. 1971 A shielded hot-wire probe for highly turbulent flows and rapidly reversing flows. Ind. Eng. Chem. Fundam. 10, 627–631.Google Scholar
Hoogendoorn, C. J. & Euser, H. 1978 Velocity profiles in the turbulent free convection boundary layer. Int. Heat Transfer Conf. Toronto 2, pp. 193–197.Google Scholar
Hussain, A. K. M. F., Kleis, S. J. & Sokolov, M. 1980 A turbulent spot in an axisymmetric free shear layer. Part 2. J. Fluid Mech. 98, 97–135.Google Scholar
Hussain, A. K. M. F.& Zaman, K. B. M. Q. 1980 Vortex pairing in circular jet under controlled excitation. Part 1. General jet response. 2. Coherent structure dynamics. J. Fluid Mech. 101, 449–544.Google Scholar
Kastrinakis, E. G., Eckelmann, H. & Willmarth, W. W. 1979 Influence of the flow velocity on a Kovasznay type vorticity probe. Rev. Sci. Instrum. 50, 759–767.Google Scholar
Kistler, A. L. 1952 The vorticity meter. M.S. thesis, The Johns Hopkins University.
Kovasznay, L. S. G. 1949 Hot wire investigation of the wake behind cylinders at low Reynolds numbers. Proc. Roy. Soc. A 198, 174–190.Google Scholar
Kovasznay, L. S. G. 1979 Measurements in intermittent and periodic flow. Proc. Dynamic Flow Conf. Marseille Baltimore 1978, pp. 133–159.
Laderman, A. J. & Demetriades, A. 1979 Turbulent shear stresses in compressible boundary layers. A.I.A.A. J. 17, 736–743.Google Scholar
Lecordier, J. C., Petit, C. & Paranthoen, P. 1981 Influence de la conduction sur la fonction de transfert de fils froids dans les très basses fréquences — Résultats expérimentaux. Int. J. Heat and Mass Transfer (in press).
Mestayer, P. & Chambaud, P. 1979 Some limitations to measurements of turbulence microstructure with hot and cold wires. Boundary-layer Met. 16, 311–329.Google Scholar
Mikulla, V. & Horstman, C. C. 1975 Turbulence stress measurements in a nonadiabatic hypersonic boundary layer. A.I.A.A. J. 13, 1607–1613.Google Scholar
Millon, F., Paranthoen, P. & Trinité, M. 1978 Influences des échanges thermiques entre le capteur et ses supports sur la mesure des fluctuations de température dans un écoulement turbulent. Int. J. Heat & Mass Transfer, 21, 1–6.Google Scholar
Moon, I. M. 1962 Direction sensitive hot wire anemometer for two dimensional flow study near a wall. A.S.M.E. Symp. Measurement in Unsteady Flow, pp. 71–75.
Morrow, T. B. & Kline, S. J. 1974 Flow: its measurement and control in science and industry. Flow measuring devices. A.S.M.E. Fluids Engng Conf. (ed. R. E. Wendt), vol. 1, part 2.
Oka, S. & Kostic, Z. 1972 Influence of wall proximity on hot wire velocity measurements. DISA Inf. 13, 29–33.Google Scholar
Perry, A. E., Smits, A. J. & Chong, M. S. 1979 The effects of certain low frequency phenomena on the calibration of hot wires. J. Fluid Mech. 90, 415–431.Google Scholar
Richardson, E. V. & McQuivey, R. S. 1968 Measurement of turbulence in water. Proc. A.S.C.E., J. Hydraulics Div. 94, 411–430.Google Scholar
Smits, A. J. & Perry, A. E. 1975 The effect of prong conduction on the dynamic behaviour of hot-wire systems. EUROMECH 63, Copenhagen.
Sokolov, M., Hussain, A.K.M.F., Kleis, S. J. & Husain, Z. D. 1980 A turbulent spot in an axisymmetric free shear layer. Part 1. J. Fluid Mech. 98, 65–95.Google Scholar
Townsend, A. A. 1979 Flow patterns of large eddies in a wake and in a boundary layer. J. Fluid Mech. 95, 515–537.Google Scholar
Trinité, M. & Beaudet, D. 1981 A method for measurements of concentration probability density function in an air—hydrogen premixed turbulent flame. A.I.A.A. J. (in press).
Wallace, J. M., Brodkey, R. S. & Eckelmann, H. 1977 Pattern-recognized structures in bounded turbulent shear flow. J. Fluid Mech. 83, 673–693.Google Scholar
Wills, J. A. B. 1962 The correction of hot-wire readings for proximity to a solid boundary. J. Fluid Mech. 12, 388–396.Google Scholar
Wills, J. A. B. 1976 A submerging hot wire for flow measurement over waves. DISA Inf. 20, 31–34.Google Scholar
Witze, P. O. 1977 Measurements of the spatial distribution and engine speed dependence of turbulent air motion in an I.C. engine. SAE Automotive Engng Congr. Detroit, paper no. 770220.
Zemskaya, A. S., Levitskiy, V. N., Repik, V. U. & Sosedko, Y. P. 1979 Effect of the proximity of the wall on hot-wire readings in laminar and turbulent boundary layers. Fluid Mech. Soviet Res. 8, 133–141.Google Scholar