1. Introduction
Depth hoar is a type of snow with distinctive crystal shapes (Reference AkitayaAkitaya, 1974). It forms in snow with densities less than about 0.3 g cm–3 at temperature gradients of about 10–25˚Cm–1 (Reference AkitayaAkitaya, 1974; Reference ArmstrongArmstrong, 1980; Reference ColbeckColbeck, 1982). If the gradient is weak, the grains will still grow, but depth-hoar characteristics may be less conspicuous or absent (Reference Stichler, Schotterer, Fröhlich, Ginot, Kull and GäggelerSturm and Benson, 1997). The high rate of vapor transport forced by the temperature gradient causes the snow to recrystallize in a few days. The snow crystals under these conditions exhibit the skeletal forms characteristic of high growth rates (Reference HobbsHobbs, 1974). Mass redistribution associated with depth-hoar formation can change concentrations of isotopic species, altering atmospheric signals prior to archivation in ice. Depth hoar has long been studied for its role in producing avalanches on steep slopes (Reference Bader, Haefeli, Bucher, Neher, Eckel and ThamsBader and others, 1954; Reference WangYosida and others, 1955). The influence of sublimation on the isotopic composition of snow is also documented (Sommerfield and others, 1991; Reference Sommerfeld, Judy, Friedman, Taylor, O’Neill and KaplanStichler and others, 2001), but restricted to a snow depth of 7 cm (Reference Sommerfeld, Judy, Friedman, Taylor, O’Neill and KaplanStichler and others, 2001). However, the development of depth hoar and its relation to stable oxygen isotopic content in snow– firn stratigraphy have received little attention.
In the Tien Shan, northwest China, well-developed depth hoar is one of the most important features in the snow–firn pack. In order to better understand the depth-hoar features, a multi-year campaign was launched in July 2002 to investigate the seasonal changes in characteristics of the snow–firn pack on Ürümqi glacier No. 1 (UG1) in eastern Tien Shan. The research was a component of the Program for Glacier Processes Investigation (PGPI) carried out by the Tien Shan Glaciological Station (TGS), Chinese Academy of Sciences (CAS), since July 2002 (Li and others, 2006).
2. Site Description and Datasets
UG1 is a small valley glacier consisting of an east and west branch located at the headwaters of the Ürümqi river, in the eastern Tien Shan (43˚05' N, 86˚49' E). From 1959 to 2003, the annual equilibrium-line altitude (ELA) of the glacier averaged approximately 4055 ma.s.l. An observation and experimental site was carefully chosen in a percolation zone of the east branch of UG1 (where the ice surface slopes about 6˚) above the ELA at 4130ma.s.l. During the sampling period, the mean annual air temperature was approximately –9.1˚C, and the precipitation, i.e. snowfall, was 700 mmw.e. (Li and others, 2006; Reference Sturm and BensonWang and others, 2006). The depth of the snow–firn pack at the site typically ranged from 1.5 m in late summer to 3 m in late spring and incorporated 3–4 years of net snow accumulation. The floor of the snow–firn pack was composed of superimposed ice, a clear and impermeable opaque ice with spherical bubbles approximately 1–5mm in diameter.
The data used in this analysis were obtained mainly from September 2004 to August 2006. Snow–firn stratigraphy was recorded every 7 days; the observations were made according to the international classification for seasonal snow on the ground (Reference ColbeckColbeck and others, 1990) and included snow-pack depth, grain size and type, density and temperature. The pit was sampled from top to bottom at 10 cm increments on a weekly basis for 11 years. After each session, the pit was refilled and the same procedure was followed 7 days later.
The wall was scaled back by at least 50 cm before the next collection round. A strict protocol was followed during this procedure to prevent contamination, including the use of disposable polyethylene gloves, masks and pre-cleaned polyethylene sample containers. All the samples were transported in insulated boxes to the laboratory, and kept frozen until analysis.
The δ18O values of the samples were determined at the State Key Laboratory of Cryosphere Science, CAS, using MAT-252 and DeltaPlus mass spectrometers, with a precision of ±0.2%.
3. Results and Discussion
3.1. Development of depth hoar in the snow–firn pack
Depth hoar is formed by sublimation and can only develop in unconsolidated snow. Conditions are especially favorable when the snow lies on top of much denser material such as ice (Reference PatersonPaterson, 1994). According to our observations, the depth hoar usually develops above the coarse-grained firn layers (density ~0.73 g cm–3) in the snow–firn pack on UG1. The essential condition for the development of depth hoar in the snow–firn pack is the temperature gradient, which is dependent on the snow–firn pack depth, air temperature and snow–firn pack temperature regime (Reference Ma and HuMa and Hu, 1990). Generally speaking, the lower the air temperature and the temperature gradient are in the snow cover, the longer the negative temperature lasts, especially with low temperatures, and the thicker the depth hoar will be.
Figure 1 shows the development of the snow–firn pack and depth hoar from August 2004 to August 2006. As was noted, the depth hoar is located in the upper layers of the snow–firn pack. The maximum snow–firn pack depth usually appears in late spring (May) or early summer (June). The development process of the depth hoar is divided into three periods: 15 October–31 January (period I), 1 February–31 March (period II) and 1 April–30 May 2005 and 1 April–10 June 2006 (period III).
Fig. 1. The development of snow–firn pack and depth hoar from August 2004 to August 2006 (dates are mm/dd/yy). The shaded gray is the position of the depth hoar, and the y axis presents the height (cm) above the surface of the superimposed ice.
Figure 2 shows the seasonal changes in depth-hoar thickness, the mean air temperature and the temperature gradient in the snow–firn pack from August 2005 to June 2006. The temperature gradient is assumed to be vertical and linear and is defined by (T i–T s)/Z s, where T i is the snow/ ice interface temperature, T s is the snow-surface temperature and Z s is the thickness of the snow–firn pack. Notice that since the temperature gradient of the snow–firn pack is weaker during the period from August to October, none of the snow–firn packs developed depth hoar.
Fig. 2. Seasonal changes in depth-hoar thickness, mean air temperature and the temperature gradient in the snow–firn pack from August 2005 to June 2006 (dates are mm/dd/yy).
During period I, the snow–firn pack depth increased from 198 to 251 cm. The daily mean air temperature decreased from –5 to –21˚C and the temperature gradient reached a maximum value of 13.0˚Cm–1 in mid-October. Generally, this is the active period for vapor transport and depth-hoar development. The depth hoar increased from 15 to 64 cm and the mean thickness accounted for 15% of the total snow–firn pack depth. An obvious linear relationship (R = 0.64, two-tailed, p = 0.01, N = 13) between the snow–firn pack and the depth-hoar thickness was found during this period (see Fig. 3).
Fig. 3. The relationship between snow–firn pack and depth-hoar thickness during period I.
During period II, the air temperature increased slowly and snow precipitation was scarce, which resulted in the decrease of the temperature gradient from 5.8 to 1.6˚Cm–1. Therefore, the snow–firn pack and depth-hoar thickness was relatively stable. The mean depth-hoar thickness was 60 cm, and accounted for 25% of the total snow–firn pack depth.
During period III, the temperature of both the air and the snow–firn pack increased, resulting in a drop in the temperature gradient in the snow–firn pack. This caused the speed of the development of the depth hoar to decrease, along with the relative thickness of depth hoar. The temperature gradient and depth-hoar thickness are obviously correlated (R = 0.77, two-tailed, P = 0.01, n = 12; see Fig. 4). This suggests that the impact of the temperature gradient on depth-hoar thickness overcomes the effect of the snow–firn pack thickness. The mean depth-hoar thickness was 36 cm, and accounted for 15% of the total snow–firn pack depth.
Fig. 4. The relationship between snow–firn pack and depth-hoar thickness during period I.
From 1 April to mid-May, the weather alternated between cold and warm with a slight warming trend, which caused the temperatures of the bottom and surface of the snow–firn pack to increase gradually. According to the observations, the temperature gradient in the snow–firn pack decreased to 0.6˚Cm–1 by mid-May. During this period, the transport of water vapor diminished, and a regime of melting–regelation metamorphism discontinuously replaced the temperature gradient for metamorphism in the snow. In early summer (June), as air temperature rose to ~0˚C, the upper section of the snow layer began to melt, leading to a rapid thinning of the snow–firn pack. The depth hoar turned completely into coarse-grained firn when the meltwater infiltrated the underlying firn layers by mid-June.
3.2. Effect of depth hoar on stable oxygen isotopic content
3.2.1. Isotopic results for the snow–firn pack
Three δ18O profiles of the snow–firn pack were selected to investigate the isotopic changes during the development process of depth-hoar formation (Fig. 5). Two of them (2 November 2004 and 25 January 2005) were subjected to strong temperature gradients and developed a typical depth hoar; another (8 September 2004) did not.
Fig. 5. The δ18O profiles of the snow–firn pack at different times (dates are mm/dd/yy).
Clearly, fractionation of the oxygen isotopic content occurred during formation of the depth hoar. The δ18O values in the bottom 15cm (78–93 cm) of the depth hoar increased by 19.1% from 8 September to 2 November 2004 and by 7.9% from 2 November 2004 to 25 January 2005. However, in the upper 10 cm (33–43 cm), δ18O values of the depth hoar decreased by 22.1% from 8 September to 2 November 2004 and by 12.0% from 2 November 2004 to 25 January 2005 (see Table 1).
Table 1. Changes in temporal δ18O values at the bottom and top of the depth hoar on different dates
![](https://static.cambridge.org/binary/version/id/urn:cambridge.org:id:binary:20171010113408621-0299:S0260305500252865:S0260305500252865_tab1.gif?pub-status=live)
3.2.2. Isotopic fractionation effect
Fractional condensation of water vapor (produced by sublimation of the snow) on growing snow crystals as the vapor moves vertically through the snow–firn pack results in isotopic fractionation (Reference Friedman, Benson, Gleason, Taylor, O’Neill and KaplanFriedman and others, 1991). The vapor pressure of the lighter isotopic molecule (H2 16O) is higher than that of the heavier isotopic molecules (HDO and H2 18O); therefore, the vapor is enriched in the light molecules in equilibrium with the solid.
Fractionation of vapor within the bottom layer of the depth hoar resulted in the loss of ‘light’ vapor upward under the influence of temperature gradients. Therefore, the bottom of the snow was depleted in the lighter species, resulting in the increase of the d value. The ‘light’ vapor appeared to have traveled up to the top of the pack where some or all of it condensed, resulting in the decrease of the d value of the snow–firn pack.
4. Summary
Long-term data were used to determine the development of depth hoar and its relation to stable oxygen isotopic content in snow–firn stratigraphy on UG1. Direct observations show that depth hoar formed during mid-October and early June at the observation site. It began to form when the temperature gradient reached a maximum value of 13.0˚Cm–1 during mid-October. From February to the end of March, it was fully developed and accounted for 25% of the total snow–firn pack depth. After April, as the weather became warmer and meltwater percolated downward, the depth hoar turned rapidly into coarse-grained firn. Fractional condensation of water vapor (produced by sublimation of the snow) on growing snow crystals as the vapor moved vertically through the snow–firn pack resulted in isotopic fractionation. The bottom 15 cm of the depth hoar show an increase in δ18O associated with mass loss, and the upper part shows a decrease associated with mass gain.
Acknowledgements
This research was supported by the Knowledge Innovation Project of the Chinese Academy of Sciences (grant KZCX2-YW-127), the China National ‘973’ Project (grant 2007-CB411501), the National Natural Science Foundation of China (grants 40631001, 40571033, 40701034, 40701035 and J0630966) and the Fok Ying Tong Education Foundation (grant 101019). Support for this research has been provided under the Program for Glacier Processes Investigation (PGPI) conducted by the Tien Shan Glaciological Station, CAS.